config: imx: Define CFG_SYS_UBOOT_BASE for Phytec's imx8mm SoM QSPI boot
PATCH 1/1 config: imx: Define CFG_SYS_UBOOT_BASE for Phytec's imx8mm SoM QSPI boot
The image offset when booting from SPI-NOR (QSPI, FSPI driver) is different than one for SD card / eMMC as extra space (0x1000) is consumed by FSPI configuration header (CONFIG_FSPI_CONF_HEADER).
Signed-off-by Lukasz Majewski <[email protected]>
--- include/configs/phycore_imx8mm.h | 9 +++++++++ 1 file changed, 9 insertions(+)
include/configs/phycore_imx8mm.h +9 -0
@@ -11,8 +11,17 @@#include <linux/stringify.h> #include <asm/arch/imx-regs.h> +#define UBOOT_ITB_OFFSET 0x57C00 +#define FSPI_CONF_BLOCK_SIZE 0x1000 +#define UBOOT_ITB_OFFSET_FSPI \ + (UBOOT_ITB_OFFSET + FSPI_CONF_BLOCK_SIZE) +#ifdef CONFIG_FSPI_CONF_HEADER +#define CFG_SYS_UBOOT_BASE \ + (QSPI0_AMBA_BASE + UBOOT_ITB_OFFSET_FSPI) +#else #define CFG_SYS_UBOOT_BASE \ (QSPI0_AMBA_BASE + CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR * 512) +#endif #ifdef CONFIG_SPL_BUILD /* malloc f used before GD_FLG_FULL_MALLOC_INIT set */
Signature · 1 line
2.39.2
Fabio Estevam
reviewerHi Lukasz,
include/configs/phycore_imx8mm.h line 17
Quoted 4 lines · Lukasz Majewski
include/configs/phycore_imx8mm.h +4
-0+#define UBOOT_ITB_OFFSET 0x57C00 +#define FSPI_CONF_BLOCK_SIZE 0x1000 +#define UBOOT_ITB_OFFSET_FSPI \ + (UBOOT_ITB_OFFSET + FSPI_CONF_BLOCK_SIZE)
Putting it in a single line helps readability.
include/configs/phycore_imx8mm.h line 20
Quoted 3 lines
include/configs/phycore_imx8mm.h +3
-0+#ifdef CONFIG_FSPI_CONF_HEADER +#define CFG_SYS_UBOOT_BASE \ + (QSPI0_AMBA_BASE + UBOOT_ITB_OFFSET_FSPI)
Same here.