Skip to contentSkip to conversation

__omap2_common_pm_late_init too early

DISCUSSION Andreas Kemnade 1 participant 1 message Oct 1, 2024

lore
Share & tools
lore
#0 lore raw

Hi,

I analyzed boot issues a bit:

On the bt200 (OMAP4460) I see:

[    1.647430] twl: not initialized
[    1.650817] twl6030_uv_to_vsel:OUT OF RANGE! non mapped vsel for

1375000 Vs max 1316660

All that is called from __omap2_common_pm_late_init

Well, the second line is the consequence of the first line. TWL is not initialized yet, nor i2c nor ti-sysc.
So that cannot work. Probably it did only work in days when async probe was not that widespread.

It is declared as
omap_late_initcall(omap2_common_pm_late_init);

In the past there were some stories where omap3 offmode could only be enabled from userspace... So maybe more trouble here because we are doing things sometimes too early.
I am a bit unsure when it should be started.

For comparison, other places where things should be done when the system should be basically known:
clk uses late_initcall_sync() instead of late_initcall() for disabling unused clocks.
regualtor uses late_initcall_sync() +30s delayed_work for disabling unused regulators.

Opinions?

Regards,
Andreas