tests/core_setmaster: simplify device handling
PATCH v2 1/1 tests/core_setmaster: simplify device handling
Refactored test setup to dynamically determine the correct drm card for testing. Instead of changing permissions for all cards, change only one that will be tested.
Problem Description:
The test fails after running the core_hotunplug@hot* subtest, where Card0 is populated as card1, This leads to a failure in the subsequent master-drop-set-user test.
Command sequence for reproducing the issue:
- Check available cards: ls /dev/dri/
- Output: by-path card0 renderD128
- Run the test: # ./core_hotunplug --r hotrebind-lateclose
- Check again: ‘ls /dev/dri/’
- Output after core_hotunplug : by-path card1 renderD129
- Run the test: # ./core_setmaster --r master-drop-set-user
- Output: gta@core_setmaster@master-drop-set-user failure
This failures on both XE and i915 for above sequence.
v2: Currented the e-mail address
--- tests/core_setmaster.c | 82 ++++++++++++++++++++++++------------------ 1 file changed, 47 insertions(+), 35 deletions(-)
tests/core_setmaster.c +47 -35
@@ -107,40 +107,31 @@ static void check_drop_set(void)drm_close_driver (master); } -static unsigned tweak_perm (uint8_t *saved_perm,unsigned max_perm,bool save) +static void tweak_perm (uint8_t *saved_perm,char *path,bool save) { -char path[256 ];struct stat st; -unsigned i; - -for (i =0 ; i < max_perm; i++) { -snprintf (path,sizeof (path),"/dev/dri/card%u" , i); - -/* Existing userspace assumes there's no gaps, do the same. */ -if (stat (path, &st) !=0 ) -break ; - -if (save) { -/* Save and toggle */ - saved_perm[i] = st.st_mode & (S_IROTH |S_IWOTH ); - st.st_mode |=S_IROTH |S_IWOTH ; - }else { -/* Clear and restore */ - st.st_mode &= ~(S_IROTH |S_IWOTH ); - st.st_mode |= saved_perm[i]; - } - -/* There's only one way for chmod to fail - race vs rmmod. -* In that case, do _not_ error/skip, since: -* - we need to restore the [correct] permissions -* - __drm_open_driver() can open another device, aka the -* failure may be irrelevant. -*/ -chmod (path, st.st_mode); +int ret; + +if (path[0 ] ==0 ) +return ; + + ret =stat (path, &st); +igt_assert_f (!ret,"stat failed with %d path=%s\n" , errno, path); + +if (save) { +/* Save and toggle */ + *saved_perm = st.st_mode & (S_IROTH |S_IWOTH ); + st.st_mode |=S_IROTH |S_IWOTH ; + }else { +/* Clear and restore */ + st.st_mode &= ~(S_IROTH |S_IWOTH ); + st.st_mode |= *saved_perm; } -return i; -} +/* There's only one way for chmod to fail - race vs rmmod. */ + ret =chmod (path, st.st_mode); +igt_assert_f (!ret,"chmod failed with %d path=%s\n" , errno, path); +} igt_main {
@@ -160,8 +151,8 @@ igt_main igt_subtest_group { -uint8_t saved_perm[255 ]; -unsigned num; +uint8_t saved_perm; +char buf[255 ];/* Upon dropping root we end up as random user, which * a) is not in the video group, and
@@ -176,8 +167,29 @@ igt_main* restored on skip or failure. */ igt_fixture { - num =tweak_perm (saved_perm,ARRAY_SIZE (saved_perm), - true); +char path[255 ]; +int len; +int fd; + +memset (buf,0 ,sizeof (buf)); + saved_perm =0 ; + + fd =__drm_open_driver (DRIVER_ANY ); +igt_assert_fd (fd); + +snprintf (path,sizeof (path),"/proc/self/fd/%d" , fd); + + len =readlink (path, buf,sizeof (buf) -1 ); +igt_assert_f (len >0 ,"readlink failed with %d path=%s\n" , errno, path); + + buf[len] ='\0' ; +if (!(strstr (buf,"/dev/dri/card" ) == buf || +strstr (buf,"/dev/dri/renderD" ) == buf)) +igt_assert_f (0 ,"Not a card nor render, path=%s\n" , buf); + +igt_assert_eq (__drm_close_driver (fd),0 ); + +tweak_perm (&saved_perm, buf, true); }igt_describe ("Ensure first normal user can Set/DropMaster" );
@@ -191,7 +203,7 @@ igt_main/* Restore the original permissions */ igt_fixture { -tweak_perm (saved_perm, num, false); +tweak_perm (&saved_perm, buf, false); } }
Signature · 1 line
2.34.1
Quoted 18 lines · Bommu Krishnaiah
Refactored test setup to dynamically determine the correct drm card for testing. Instead of changing permissions for all cards, change only one that will be tested.
Problem Description:
The test fails after running thecore_hotunplug@hot*subtest, where Card0 is populated as card1, This leads to a failure in the subsequentmaster-drop-set-usertest.Command sequence for reproducing the issue:
- Check available cards:ls /dev/dri/
- Output: by-path card0 renderD128
- Run the test:# ./core_hotunplug --r hotrebind-lateclose
- Check again: ‘ls /dev/dri/’
- Output aftercore_hotunplug: by-path card1 renderD129
- Run the test:# ./core_setmaster --r master-drop-set-user
- Output: gta@core_setmaster@master-drop-set-user failure
Quoted 3 lines
This failures on both XE and i915 for above sequence.
v2: Currented the e-mail address
/s/currented/corrected/
Quoted 129 lines
Signed-off-by Bommu Krishnaiah <[email protected]>Cc Emil Velikov <[email protected]>Cc Himal Prasad Ghimiray <[email protected]>Cc Kamil Konieczny <[email protected]>--- tests/core_setmaster.c | 82 ++++++++++++++++++++++++------------------ 1 file changed, 47 insertions(+), 35 deletions(-)tests/core_setmaster.c +47
-35@@ -107,40 +107,31 @@ static void check_drop_set(void)drm_close_driver (master); } -static unsigned tweak_perm (uint8_t *saved_perm,unsigned max_perm,bool save) +static void tweak_perm (uint8_t *saved_perm,char *path,bool save) { -char path[256 ];struct stat st; -unsigned i; - -for (i =0 ; i < max_perm; i++) { -snprintf (path,sizeof (path),"/dev/dri/card%u" , i); - -/* Existing userspace assumes there's no gaps, do the same. */ -if (stat (path, &st) !=0 ) -break ; - -if (save) { -/* Save and toggle */ - saved_perm[i] = st.st_mode & (S_IROTH |S_IWOTH ); - st.st_mode |=S_IROTH |S_IWOTH ; - }else { -/* Clear and restore */ - st.st_mode &= ~(S_IROTH |S_IWOTH ); - st.st_mode |= saved_perm[i]; - } - -/* There's only one way for chmod to fail - race vs rmmod. -* In that case, do _not_ error/skip, since: -* - we need to restore the [correct] permissions -* - __drm_open_driver() can open another device, aka the -* failure may be irrelevant. -*/ -chmod (path, st.st_mode); +int ret; + +if (path[0 ] ==0 ) +return ; + + ret =stat (path, &st); +igt_assert_f (!ret,"stat failed with %d path=%s\n" , errno, path); + +if (save) { +/* Save and toggle */ + *saved_perm = st.st_mode & (S_IROTH |S_IWOTH ); + st.st_mode |=S_IROTH |S_IWOTH ; + }else { +/* Clear and restore */ + st.st_mode &= ~(S_IROTH |S_IWOTH ); + st.st_mode |= *saved_perm; } -return i; -} +/* There's only one way for chmod to fail - race vs rmmod. */ + ret =chmod (path, st.st_mode); +igt_assert_f (!ret,"chmod failed with %d path=%s\n" , errno, path); +} igt_main {@@ -160,8 +151,8 @@ igt_main igt_subtest_group { -uint8_t saved_perm[255 ]; -unsigned num; +uint8_t saved_perm; +char buf[255 ];/* Upon dropping root we end up as random user, which * a) is not in the video group, and @@ -176,8 +167,29 @@ igt_main* restored on skip or failure. */ igt_fixture { - num =tweak_perm (saved_perm,ARRAY_SIZE (saved_perm), - true); +char path[255 ]; +int len; +int fd; + +memset (buf,0 ,sizeof (buf)); + saved_perm =0 ; + + fd =__drm_open_driver (DRIVER_ANY ); +igt_assert_fd (fd); + +snprintf (path,sizeof (path),"/proc/self/fd/%d" , fd); + + len =readlink (path, buf,sizeof (buf) -1 ); +igt_assert_f (len >0 ,"readlink failed with %d path=%s\n" , errno, path); + + buf[len] ='\0' ; +if (!(strstr (buf,"/dev/dri/card" ) == buf || +strstr (buf,"/dev/dri/renderD" ) == buf)) +igt_assert_f (0 ,"Not a card nor render, path=%s\n" , buf); + +igt_assert_eq (__drm_close_driver (fd),0 ); + +tweak_perm (&saved_perm, buf, true); }igt_describe ("Ensure first normal user can Set/DropMaster" );@@ -191,7 +203,7 @@ igt_main/* Restore the original permissions */ igt_fixture { -tweak_perm (saved_perm, num, false); +tweak_perm (&saved_perm, buf, false); }}