arm: dts: aspeed: Blueridge and Rainer: Add VRM presence GPIOs
Subsystems (2)
PATCH v2 1/1 arm: dts: aspeed: Blueridge and Rainer: Add VRM presence GPIOs
Add GPIO line names to the GPIO expander to describe DCM and VRM presence detection lines.
Signed-off-by Eddie James <[email protected]>
---
Changes since v1:
- Fix lines that were too long
arch/arm/boot/dts/aspeed/aspeed-bmc-ibm-blueridge.dts | 5 +++-- arch/arm/boot/dts/aspeed/aspeed-bmc-ibm-rainier.dts | 5 +++-- 2 files changed, 6 insertions(+), 4 deletions(-)
arch/arm/boot/dts/aspeed/aspeed-bmc-ibm-blueridge.dts +3 -2
@@ -1232,8 +1232,9 @@ led-controller@60 { #gpio-cells = <2>; gpio-line-names = - "", "", "", "", "", "", "", "", - "", "", "", "", "", "", "power-config-full-load", ""; + "", "", "", "", "", "", "P10_DCM0_PRES", "P10_DCM1_PRES", + "", "", "", "", "PRESENT_VRM_DCM0_N", "PRESENT_VRM_DCM1_N", + "power-config-full-load", ""; }; led-controller@61 {
arch/arm/boot/dts/aspeed/aspeed-bmc-ibm-rainier.dts +3 -2
@@ -1280,8 +1280,9 @@ pca_pres3: pca9552@60 { #gpio-cells = <2>; gpio-line-names = - "", "", "", "", "", "", "", "", - "", "", "", "", "", "", "power-config-full-load", ""; + "", "", "", "", "", "", "P10_DCM0_PRES", "P10_DCM1_PRES", + "", "", "", "", "PRESENT_VRM_DCM0_N", "PRESENT_VRM_DCM1_N", + "power-config-full-load", ""; }; pca_pres2: pca9552@61 {
Signature · 1 line
2.43.5
Andrew Jeffery
maintainerQuoted 4 lines · Eddie James
Add GPIO line names to the GPIO expander to describe DCM and VRM presence detection lines.
Thanks, I've applied this to be picked up through the BMC tree.
--
Andrew Jeffery <[email protected]>