ARM: dts: imx28-sps1: Fix GPIO LEDs description

From: Fabio Estevam <[email protected]>

According to leds-gpio.yaml, the LED nodes should not contain unit addresses. Remove them.

Also, 'default-trigger' is not a valid property. Change it to 'linux,default-trigger'.

These changes fix the following dt-schema warnings:

led@1: Unevaluated properties are not allowed ('reg' was unexpected)
led@2: Unevaluated properties are not allowed ('reg' was unexpected)
led@3: Unevaluated properties are not allowed ('default-trigger', 'reg' were unexpected)
leds: '#address-cells', '#size-cells' do not match any of the regexes: '(^led-[0-9a-f]$|led)', 'pinctrl-[0-9]+'

---
 arch/arm/boot/dts/nxp/mxs/imx28-sps1.dts | 13 ++++---------
 1 file changed, 4 insertions(+), 9 deletions(-)

index 0f01dded4e3d..ca62e7933116 100644
@@ -24,30 +24,25 @@ reg_usb0_vbus: regulator-0 {
 	};
 
 	leds {
-		#address-cells = <1>;
-		#size-cells = <0>;
 		compatible = "gpio-leds";
 		status = "okay";
 
-		led@1 {
+		led-1 {
 			label = "sps1-1:yellow:user";
 			gpios = <&gpio0 6 0>;
 			linux,default-trigger = "heartbeat";
-			reg = <0>;
 		};
 
-		led@2 {
+		led-2 {
 			label = "sps1-2:red:user";
 			gpios = <&gpio0 3 0>;
 			linux,default-trigger = "heartbeat";
-			reg = <1>;
 		};
 
-		led@3 {
+		led-3 {
 			label = "sps1-3:red:user";
 			gpios = <&gpio0 0 0>;
-			default-trigger = "heartbeat";
-			reg = <2>;
+			linux,default-trigger = "heartbeat";
 		};
 
 	};

2.34.1

Applied, thanks!