wifi: brcmsmac: Spelling corrections
PATCH 1/1 wifi: brcmsmac: Spelling corrections
Various spelling corrections as flagged by codespell.
Signed-off-by Simon Horman <[email protected]>
--- drivers/net/wireless/broadcom/brcm80211/brcmsmac/aiutils.c | 6 +++--- drivers/net/wireless/broadcom/brcm80211/brcmsmac/aiutils.h | 2 +- drivers/net/wireless/broadcom/brcm80211/brcmsmac/ampdu.c | 4 ++-- drivers/net/wireless/broadcom/brcm80211/brcmsmac/channel.c | 4 ++-- drivers/net/wireless/broadcom/brcm80211/brcmsmac/dma.c | 2 +- drivers/net/wireless/broadcom/brcm80211/brcmsmac/mac80211_if.c | 4 ++-- drivers/net/wireless/broadcom/brcm80211/brcmsmac/main.c | 4 ++-- drivers/net/wireless/broadcom/brcm80211/brcmsmac/main.h | 2 +- drivers/net/wireless/broadcom/brcm80211/brcmsmac/pmu.c | 2 +- 9 files changed, 15 insertions(+), 15 deletions(-)
drivers/net/wireless/broadcom/brcm80211/brcmsmac/aiutils.c +3 -3
@@ -198,7 +198,7 @@#define CST4313_SPROM_OTP_SEL_SHIFT 0/* 4313 Chip specific ChipControl register bits */ -/* 12 mA drive strengh for later 4313 */ +/* 12 mA drive strength for later 4313 */ #define CCTRL_4313_12MA_LED_DRIVE 0x00000007/* Manufacturer Ids */
@@ -453,7 +453,7 @@ ai_buscore_setup(struct si_info *sii, struct bcma_device *cc)/* get chipcommon chipstatus */ sii->chipst =bcma_read32 (cc,CHIPCREGOFFS (chipstatus)); -/* get chipcommon capabilites */ +/* get chipcommon capabilities */ sii->pub.cccaps =bcma_read32 (cc,CHIPCREGOFFS (capabilities));/* get pmu rev and caps */
@@ -657,7 +657,7 @@ u16 ai_clkctl_fast_pwrup_delay(struct si_pub *sih) }/* -* clock control policy function throught chipcommon +* clock control policy function through chipcommon * * set dynamic clk control mode (forceslow, forcefast, dynamic) * returns true if we are forcing fast clock
drivers/net/wireless/broadcom/brcm80211/brcmsmac/aiutils.h +1 -1
@@ -76,7 +76,7 @@* conventions for the use the flash space: */ -/* Minumum amount of flash we support */ +/* Minimum amount of flash we support */ #define FLASH_MIN 0x00020000/* Minimum flash size */ #define CC_SROM_OTP 0x800/* SROM/OTP address space */
drivers/net/wireless/broadcom/brcm80211/brcmsmac/ampdu.c +2 -2
@@ -479,7 +479,7 @@ void brcms_c_ampdu_reset_session(struct brcms_ampdu_session *session,/* * Preps the given packet for AMPDU based on the session data. If the -* frame cannot be accomodated in the current session, -ENOSPC is +* frame cannot be accommodated in the current session, -ENOSPC is * returned. */ int brcms_c_ampdu_add_frame(struct brcms_ampdu_session *session,
@@ -529,7 +529,7 @@ int brcms_c_ampdu_add_frame(struct brcms_ampdu_session *session, }/* -* Now that we're sure this frame can be accomodated, update the +* Now that we're sure this frame can be accommodated, update the * session information. */ session->ampdu_len += len;
drivers/net/wireless/broadcom/brcm80211/brcmsmac/channel.c +2 -2
@@ -445,7 +445,7 @@ brcms_c_channel_reg_limits(struct brcms_cm_info *wlc_cm, u16 chanspec,/* * OFDM 40 MHz SISO has the same power as the corresponding -* MCS0-7 rate unless overriden by the locale specific code. +* MCS0-7 rate unless overridden by the locale specific code. * We set this value to 0 as a flag (presumably 0 dBm isn't * a possibility) and then copy the MCS0-7 value to the 40 MHz * value if it wasn't explicitly set.
@@ -479,7 +479,7 @@ brcms_c_channel_reg_limits(struct brcms_cm_info *wlc_cm, u16 chanspec,/* * 20 MHz has the same power as the corresponding OFDM rate -* unless overriden by the locale specific code. +* unless overridden by the locale specific code. */ txpwr->mcs_20_siso[i] = txpwr->ofdm[i]; txpwr->mcs_40_siso[i] =0 ;
drivers/net/wireless/broadcom/brcm80211/brcmsmac/dma.c +1 -1
@@ -1348,7 +1348,7 @@ static void prep_ampdu_frame(struct dma_info *di, struct sk_buff *p) ret =brcms_c_ampdu_add_frame (session, p);if (ret == -ENOSPC ) {/* -* AMPDU cannot accomodate this frame. Close out the in- +* AMPDU cannot accommodate this frame. Close out the in- * progress AMPDU session and start a new one. */ ampdu_finalize (di);
drivers/net/wireless/broadcom/brcm80211/brcmsmac/mac80211_if.c +2 -2
@@ -48,9 +48,9 @@ FIF_BCN_PRBRESP_PROMISC | \ FIF_PSPOLL) -#define CHAN2GHZ (channel, freqency, chflags) { \ +#define CHAN2GHZ (channel, frequency, chflags) { \ .band = NL80211_BAND_2GHZ, \ - .center_freq = (freqency), \ + .center_freq = (frequency), \ .hw_value = (channel), \ .flags = chflags, \ .max_antenna_gain = 0, \
drivers/net/wireless/broadcom/brcm80211/brcmsmac/main.c +2 -2
@@ -921,7 +921,7 @@ brcms_c_dotxstatus(struct brcms_c_info *wlc, struct tx_status *txs)* The "fallback limit" is the number of tx attempts a given * MPDU is sent at the "primary" rate. Tx attempts beyond that * limit are sent at the "secondary" rate. -* A 'short frame' does not exceed RTS treshold. +* A 'short frame' does not exceed RTS threshold. */ u16 sfbl,/* Short Frame Rate Fallback Limit */ lfbl, /* Long Frame Rate Fallback Limit */
@@ -6259,7 +6259,7 @@ brcms_c_d11hdrs_mac80211(struct brcms_c_info *wlc, struct ieee80211_hw *hw, }/* -* Currently only support same setting for primay and +* Currently only support same setting for primary and * fallback rates. Unify flags for each rate into a * single value for the frame */
drivers/net/wireless/broadcom/brcm80211/brcmsmac/main.h +1 -1
@@ -603,7 +603,7 @@ enum brcms_bss_type {* cur_etheraddr: h/w address * flags: BSSCFG flags; see below * -* current_bss: BSS parms in ASSOCIATED state +* current_bss: BSS parameters in ASSOCIATED state * * * ID: 'unique' ID of this bsscfg, assigned at bsscfg allocation
drivers/net/wireless/broadcom/brcm80211/brcmsmac/pmu.c +1 -1
@@ -31,7 +31,7 @@#define EXT_ILP_HZ 32768/* -* Duration for ILP clock frequency measurment in milliseconds +* Duration for ILP clock frequency measurement in milliseconds * * remark: 1000 must be an integer multiple of this duration */
Quoted 1 line · Simon Horman
Various spelling corrections as flagged by codespell.
Have to admit I merely scanned through this patch. So for what it's worth it look okay to me so...
Acked-by Arend van Spriel <[email protected]>
Quoted 12 lines
Signed-off-by Simon Horman <[email protected]>---
drivers/net/wireless/broadcom/brcm80211/brcmsmac/aiutils.c | 6 +++--- drivers/net/wireless/broadcom/brcm80211/brcmsmac/aiutils.h | 2 +- drivers/net/wireless/broadcom/brcm80211/brcmsmac/ampdu.c | 4 ++-- drivers/net/wireless/broadcom/brcm80211/brcmsmac/channel.c | 4 ++-- drivers/net/wireless/broadcom/brcm80211/brcmsmac/dma.c | 2 +- drivers/net/wireless/broadcom/brcm80211/brcmsmac/mac80211_if.c | 4 ++-- drivers/net/wireless/broadcom/brcm80211/brcmsmac/main.c | 4 ++-- drivers/net/wireless/broadcom/brcm80211/brcmsmac/main.h | 2 +- drivers/net/wireless/broadcom/brcm80211/brcmsmac/pmu.c | 2 +- 9 files changed, 15 insertions(+), 15 deletions(-)