Skip to contentSkip to conversation

dt-bindings: interrupt-controller: Convert jcore,aic to DT schema

PATCH New Rob Herring (Arm) 1 participant 1 message May 5, 2025

Subsystems (2)
Device tree bindings irqchip drivers
lore
Share & tools
lore

Rob Herring (Arm)

author maintainer
#0 lore raw

PATCH 1/1 dt-bindings: interrupt-controller: Convert jcore,aic to DT schema

Convert the J-Core advanced interrupt controller binding to schema format. It's a straight-forward conversion of the typical interrupt controller.

Signed-off-by Rob Herring (Arm) <[email protected]>
---
 .../interrupt-controller/jcore,aic.txt        | 26 -----------
 .../interrupt-controller/jcore,aic.yaml       | 43 +++++++++++++++++++
 2 files changed, 43 insertions(+), 26 deletions(-)
 delete mode 100644 Documentation/devicetree/bindings/interrupt-controller/jcore,aic.txt
 create mode 100644 Documentation/devicetree/bindings/interrupt-controller/jcore,aic.yaml
Documentation/devicetree/bindings/interrupt-controller/jcore,aic.txt deleted +0 -26
deleted file mode 100644
index ee2ad36f8df8..000000000000
@@ -1,26 +0,0 @@
-J-Core Advanced Interrupt Controller
-
-Required properties:
-
-- compatible: Should be "jcore,aic1" for the (obsolete) first-generation aic
-  with 8 interrupt lines with programmable priorities, or "jcore,aic2" for
-  the "aic2" core with 64 interrupts.
-
-- reg: Memory region(s) for configuration. For SMP, there should be one
-  region per cpu, indexed by the sequential, zero-based hardware cpu
-  number.
-
-- interrupt-controller: Identifies the node as an interrupt controller
-
-- #interrupt-cells: Specifies the number of cells needed to encode an
-  interrupt source. The value shall be 1.
-
-
-Example:
-
-aic: interrupt-controller@200 {
-	compatible = "jcore,aic2";
-	reg = < 0x200 0x30 0x500 0x30 >;
-	interrupt-controller;
-	#interrupt-cells = <1>;
-};
Documentation/devicetree/bindings/interrupt-controller/jcore,aic.yaml new file +43 -0

43 lines not on this page · raw message

Signature · 1 line
2.47.2