dt-bindings: interrupt-controller: Convert ti,keystone-irq to DT schema

deleted file mode 100644
index 5f94d7739d8d..000000000000
@@ -1,36 +0,0 @@
-Keystone 2 IRQ controller IP
-
-On Keystone SOCs, DSP cores can send interrupts to ARM
-host using the IRQ controller IP. It provides 28 IRQ signals to ARM.
-The IRQ handler running on HOST OS can identify DSP signal source by
-analyzing SRCCx bits in IPCARx registers. This is one of the component
-used by the IPC mechanism used on Keystone SOCs.
-
-Required Properties:
-- compatible: should be "ti,keystone-irq"
-- ti,syscon-dev : phandle and offset pair. The phandle to syscon used to
-			access device control registers and the offset inside
-			device control registers range.
-- interrupt-controller : Identifies the node as an interrupt controller
-- #interrupt-cells : Specifies the number of cells needed to encode interrupt
-					 source should be 1.
-- interrupts: interrupt reference to primary interrupt controller
-
-Please refer to interrupts.txt in this directory for details of the common
-Interrupt Controllers bindings used by client devices.
-
-Example:
-	kirq0: keystone_irq0@26202a0 {
-		compatible = "ti,keystone-irq";
-		ti,syscon-dev = <&devctrl 0x2a0>;
-		interrupts = <GIC_SPI 4 IRQ_TYPE_EDGE_RISING>;
-		interrupt-controller;
-		#interrupt-cells = <1>;
-	};
-
-	dsp0: dsp0 {
-		compatible = "linux,rproc-user";
-		...
-		interrupt-parent = <&kirq0>;
-		interrupts = <10 2>;
-	};

63 lines not on this page · raw message