arm: mach-k3: j784s4: Call do_board_detect() before DDR probing
Subsystems (2)
PATCH 1/1 arm: mach-k3: j784s4: Call do_board_detect() before DDR probing
From: Emanuele Ghidoli <[email protected]>
Call do_board_detect() hook before the K3 DDRSS driver gets probed. It will allow boards to adjust DDR timings in do_board_detect().
--- arch/arm/mach-k3/j784s4/j784s4_init.c | 4 ++++ 1 file changed, 4 insertions(+)
arch/arm/mach-k3/j784s4/j784s4_init.c +4 -0
@@ -242,6 +242,10 @@ void board_init_f(ulong dummy)int ret;k3_spl_init (); + +/* Perform board detection */ +do_board_detect (); +k3_mem_init ();if (IS_ENABLED (CONFIG_CPU_V7R ) &&IS_ENABLED (CONFIG_K3_AVS0 )) {
Signature · 1 line
2.43.0
Quoted 4 lines · Emanuele Ghidoli
Call
do_board_detect()hook before the K3 DDRSS driver gets probed. It will allow boards to adjust DDR timings indo_board_detect().
Applied to u-boot/next, thanks!
[1/1] arm: mach-k3: j784s4: Call do_board_detect() before DDR probing
commit: 79ae5510a211d788b01cc5cb7f4ad15e9f5f528f
Signature · 1 line
Tom
Hi Tom, Hi Bryan,
Am Fr., 13. Juni 2025 um 00:49 Uhr schrieb Tom Rini <[email protected]>:
Quoted 5 lines · Emanuele Ghidoli
Quoted 4 lines
Call
do_board_detect()hook before the K3 DDRSS driver gets probed. It will allow boards to adjust DDR timings indo_board_detect().
I think the comment from Tom is also valid like the one in [1] about not doing things over and over again.
[1] https://lore.kernel.org/u-boot/20250612143808.GM1382132@bill-the-cat/
--
Heiko
Quoted 12 lines
Quoted 2 lines
Applied to u-boot/next, thanks!
[1/1] arm: mach-k3: j784s4: Call
do_board_detect()before DDR probingcommit: 79ae5510a211d788b01cc5cb7f4ad15e9f5f528f--
Tom