dt-bindings: phy: Convert brcm,ns2-drd-phy to DT schema
Subsystems (2)
Rob Herring (Arm)
maintainerPATCH 1/1 dt-bindings: phy: Convert brcm,ns2-drd-phy to DT schema
Convert the Broadcom NS2 USB2 PHY binding to DT schema format. It's a straight forward conversion.
Signed-off-by Rob Herring (Arm) <[email protected]>
--- .../bindings/phy/brcm,ns2-drd-phy.txt | 30 --------- .../bindings/phy/brcm,ns2-drd-phy.yaml | 62 +++++++++++++++++++ 2 files changed, 62 insertions(+), 30 deletions(-) delete mode 100644 Documentation/devicetree/bindings/phy/brcm,ns2-drd-phy.txt create mode 100644 Documentation/devicetree/bindings/phy/brcm,ns2-drd-phy.yaml
Documentation/devicetree/bindings/phy/brcm,ns2-drd-phy.txt deleted +0 -30
@@ -1,30 +0,0 @@ -BROADCOM NORTHSTAR2 USB2 (DUAL ROLE DEVICE) PHY - -Required properties: - - compatible: brcm,ns2-drd-phy - - reg: offset and length of the NS2 PHY related registers. - - reg-names - The below registers must be provided. - icfg - for DRD ICFG configurations - rst-ctrl - for DRD IDM reset - crmu-ctrl - for CRMU core vdd, PHY and PHY PLL reset - usb2-strap - for port over current polarity reversal - - #phy-cells: Must be 0. No args required. - - vbus-gpios: vbus gpio binding - - id-gpios: id gpio binding - -Refer to phy/phy-bindings.txt for the generic PHY binding properties - -Example: - usbdrd_phy: phy@66000960 { - #phy-cells = <0>; - compatible = "brcm,ns2-drd-phy"; - reg = <0x66000960 0x24>, - <0x67012800 0x4>, - <0x6501d148 0x4>, - <0x664d0700 0x4>; - reg-names = "icfg", "rst-ctrl", - "crmu-ctrl", "usb2-strap"; - id-gpios = <&gpio_g 30 0>; - vbus-gpios = <&gpio_g 31 0>; - };
Documentation/devicetree/bindings/phy/brcm,ns2-drd-phy.yaml new file +62 -0
62 lines not on this page · raw message
Signature · 1 line
2.47.2