dt-bindings: phy: Convert marvell,berlin2-sata-phy to DT schema
Subsystems (2)
Rob Herring (Arm)
maintainerPATCH 1/1 dt-bindings: phy: Convert marvell,berlin2-sata-phy to DT schema
Convert the Marvell Berlin2 SATA PHY binding to DT schema format. It's a straight forward conversion.
Signed-off-by Rob Herring (Arm) <[email protected]>
--- .../bindings/phy/berlin-sata-phy.txt | 36 --------- .../phy/marvell,berlin2-sata-phy.yaml | 76 +++++++++++++++++++ 2 files changed, 76 insertions(+), 36 deletions(-) delete mode 100644 Documentation/devicetree/bindings/phy/berlin-sata-phy.txt create mode 100644 Documentation/devicetree/bindings/phy/marvell,berlin2-sata-phy.yaml
Documentation/devicetree/bindings/phy/berlin-sata-phy.txt deleted +0 -36
@@ -1,36 +0,0 @@ -Berlin SATA PHY ---------------- - -Required properties: -- compatible: should be one of - "marvell,berlin2-sata-phy" - "marvell,berlin2q-sata-phy" -- address-cells: should be 1 -- size-cells: should be 0 -- phy-cells: from the generic PHY bindings, must be 1 -- reg: address and length of the register -- clocks: reference to the clock entry - -Sub-nodes: -Each PHY should be represented as a sub-node. - -Sub-nodes required properties: -- reg: the PHY number - -Example: - sata_phy: phy@f7e900a0 { - compatible = "marvell,berlin2q-sata-phy"; - reg = <0xf7e900a0 0x200>; - clocks = <&chip CLKID_SATA>; - #address-cells = <1>; - #size-cells = <0>; - #phy-cells = <1>; - - sata-phy@0 { - reg = <0>; - }; - - sata-phy@1 { - reg = <1>; - }; - };
Documentation/devicetree/bindings/phy/marvell,berlin2-sata-phy.yaml new file +76 -0
76 lines not on this page · raw message
Signature · 1 line
2.47.2