dts: pcm052: bk4: Use proper compatible for QSPI SPI-NOR memory
PATCH 1/1 dts: pcm052: bk4: Use proper compatible for QSPI SPI-NOR memory
In the contemporary U-Boot the "spi-flash" compatible is used only when CONFIG_$(PHASE_)SPI_FLASH_TINY is defined so spi-nor-tiny.c is compiled.
As vf610 devices are not using SPL at all, the SPI_FLASH_TINY is not defined and no QSPI flash child nodes are considered as valid ones.
The result is that the 'sf probe' command fails and SPI NOR memory is not accessible on e.g. BK4 device.
The fix is to use proper compatible - in this case "jedec,spi-nor".
--- arch/arm/dts/vf610-pcm052.dtsi | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
arch/arm/dts/vf610-pcm052.dtsi +2 -2
@@ -244,7 +244,7 @@ qflash0: spi_flash@0 { #address-cells = <1>; #size-cells = <1>; - compatible = "spi-flash"; + compatible = "jedec,spi-nor"; spi-max-frequency = <108000000>; reg = <0>; };
@@ -252,7 +252,7 @@ qflash1: spi_flash@1 { #address-cells = <1>; #size-cells = <1>; - compatible = "spi-flash"; + compatible = "jedec,spi-nor"; spi-max-frequency = <66000000>; reg = <1>; };
Signature · 1 line
2.39.5
Quoted 7 lines · Lukasz Majewski
In the contemporary U-Boot the "spi-flash" compatible is used only when CONFIG_$(PHASE_)SPI_FLASH_TINY is defined so
spi-nor-tiny.cis compiled.As vf610 devices are not using SPL at all, the
SPI_FLASH_TINYis not defined and no QSPI flash child nodes are considered as valid ones.
Quoted 7 lines
The result is that the 'sf probe' command fails and SPI NOR memory is not accessible on e.g. BK4 device.
The fix is to use proper compatible - in this case "jedec,spi-nor".
Signed-off-by Lukasz Majewski <[email protected]>---
Applied to u-boot-imx/next, thanks.