Skip to contentSkip to conversation

net: phy: air_en8811h: Introduce resume/suspend and clk_restore_context to ensure correct CKO settings after network interface reinitialization.

PATCH Applied Lucien.Jheng 3 participants 3 messages Jun 30, 2025 – Jul 2, 2025

Subsystems (4)
lore
Share & tools
lore
#0 lore raw

PATCH v2 1/1 net: phy: air_en8811h: Introduce resume/suspend and clk_restore_context to ensure correct CKO settings after network interface reinitialization.

If the user reinitializes the network interface, the PHY will reinitialize, and the CKO settings will revert to their initial configuration(be enabled). To prevent CKO from being re-enabled, en8811h_clk_restore_context and en8811h_resume were added
to ensure the CKO settings remain correct.

---
Change in PATCH v2:
air_en8811h.c:
* Fix: build errors about using __ functions.
* Add clk_save_context to handle CKO state.
* Add cko_is_enabled to track CKO state.

 drivers/net/phy/air_en8811h.c | 45 +++++++++++++++++++++++++++++++----
 1 file changed, 41 insertions(+), 4 deletions(-)
drivers/net/phy/air_en8811h.c +41 -4
index 57fbd8df9438..badd65f0ccee 100644
@@ -11,6 +11,7 @@
  * Copyright (C) 2023 Airoha Technology Corp.
  */
 
+#include <linux/clk.h>
 #include <linux/clk-provider.h>
 #include <linux/phy.h>
 #include <linux/firmware.h>
@@ -157,6 +158,7 @@ struct en8811h_priv {
 	struct led		led[EN8811H_LED_COUNT];
 	struct clk_hw		hw;
 	struct phy_device	*phydev;
+	unsigned int		cko_is_enabled;
 };
 
 enum {
@@ -865,11 +867,30 @@ static int en8811h_clk_is_enabled(struct clk_hw *hw)
 	return (pbus_value & EN8811H_CLK_CGM_CKO);
 }
 
+static int en8811h_clk_save_context(struct clk_hw *hw)
+{
+	struct en8811h_priv *priv = clk_hw_to_en8811h_priv(hw);
+
+	priv->cko_is_enabled = en8811h_clk_is_enabled(hw);
+
+	return 0;
+}
+
+static void en8811h_clk_restore_context(struct clk_hw *hw)
+{
+	struct en8811h_priv *priv = clk_hw_to_en8811h_priv(hw);
+
+	if (!priv->cko_is_enabled)
+		en8811h_clk_disable(hw);
+}
+
 static const struct clk_ops en8811h_clk_ops = {
-	.recalc_rate	= en8811h_clk_recalc_rate,
-	.enable		= en8811h_clk_enable,
-	.disable	= en8811h_clk_disable,
-	.is_enabled	= en8811h_clk_is_enabled,
+	.recalc_rate		= en8811h_clk_recalc_rate,
+	.enable			= en8811h_clk_enable,
+	.disable		= en8811h_clk_disable,
+	.is_enabled		= en8811h_clk_is_enabled,
+	.save_context		= en8811h_clk_save_context,
+	.restore_context	= en8811h_clk_restore_context,
 };
 
 static int en8811h_clk_provider_setup(struct device *dev, struct clk_hw *hw)
@@ -1149,6 +1170,20 @@ static irqreturn_t en8811h_handle_interrupt(struct phy_device *phydev)
 	return IRQ_HANDLED;
 }
 
+static int en8811h_resume(struct phy_device *phydev)
+{
+	clk_restore_context();
+
+	return genphy_resume(phydev);
+}
+
+static int en8811h_suspend(struct phy_device *phydev)
+{
+	clk_save_context();
+
+	return genphy_suspend(phydev);
+}
+
 static struct phy_driver en8811h_driver[] = {
 {
 	PHY_ID_MATCH_MODEL(EN8811H_PHY_ID),
@@ -1159,6 +1194,8 @@ static struct phy_driver en8811h_driver[] = {
 	.get_rate_matching	= en8811h_get_rate_matching,
 	.config_aneg		= en8811h_config_aneg,
 	.read_status		= en8811h_read_status,
+	.resume			= en8811h_resume,
+	.suspend		= en8811h_suspend,
 	.config_intr		= en8811h_clear_intr,
 	.handle_interrupt	= en8811h_handle_interrupt,
 	.led_hw_is_supported	= en8811h_led_hw_is_supported,

--
2.34.1

maintainer Reviewed-by on v2 1/1
#1 lore raw
Quoted 7 lines · Lucien.Jheng

If the user reinitializes the network interface, the PHY will reinitialize, and the CKO settings will revert to their initial configuration(be enabled). To prevent CKO from being re-enabled, en8811h_clk_restore_context and en8811h_resume were added
to ensure the CKO settings remain correct.

Andrew

#2 lore raw
In reply to Lucien.Jheng
This patch was applied to netdev/net-next.git (main) by Jakub Kicinski <[email protected]>:

Hello:

This patch was applied to netdev/net-next.git (main) by Jakub Kicinski <[email protected]>:

Quoted 9 lines · On Mon, 30 Jun 2025 23:41:47 +0800 you wrote:

If the user reinitializes the network interface, the PHY will reinitialize, and the CKO settings will revert to their initial configuration(be enabled). To prevent CKO from being re-enabled, en8811h_clk_restore_context and en8811h_resume were added
to ensure the CKO settings remain correct.

[...]

Here is the summary with links:
- [v2,net-next,1/1] net: phy: air_en8811h: Introduce resume/suspend and clk_restore_context to ensure correct CKO settings after network interface reinitialization.

    https://git.kernel.org/netdev/net-next/c/6b9c9def95cb

You are awesome, thank you!

Signature · 2 lines
Deet-doot-dot, I am a bot.
https://korg.docs.kernel.org/patchwork/pwbot.html