Skip to contentSkip to conversation

configs: microchip_mpfs_icicle: disable DEBUG_UART

PATCH In review Conor Dooley 2 participants 2 messages Jul 7, 2025 – Jul 16, 2025

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 configs: microchip_mpfs_icicle: disable DEBUG_UART

From: Conor Dooley <[email protected]>

By default DEBUG_UART uses the SBI DBCN extension on S-Mode RISC-V platforms, but the Icicle Kit's firmware doesn't support it. Since DEBUG_UART is getting turned on automagically and this is somewhat misleading, disable it in the Icicle kit's defconfig.

---
CC: Conor Dooley <[email protected]>
CC: Cyril Jean <[email protected]>
CC: Tom Rini <[email protected]>
CC: Leo Yu-Chi Liang <[email protected]>
CC: [email protected]

---
 configs/microchip_mpfs_icicle_defconfig | 1 +
 1 file changed, 1 insertion(+)
configs/microchip_mpfs_icicle_defconfig +1 -0
index bb110225488..6937aa224a1 100644
@@ -7,6 +7,7 @@ CONFIG_ENV_SIZE=0x2000
 CONFIG_DEFAULT_DEVICE_TREE="microchip/mpfs-icicle-kit"
 CONFIG_SYS_LOAD_ADDR=0x80200000
 CONFIG_SYS_MEM_TOP_HIDE=0x400000
+# CONFIG_DEBUG_UART is not set
 CONFIG_TARGET_MICROCHIP_ICICLE=y
 CONFIG_ARCH_RV64I=y
 CONFIG_RISCV_SMODE=y
Signature · 1 line
2.45.2
Reviewed-by on v1 1/1
#1 lore raw
Quoted 14 lines · Conor Dooley

From: Conor Dooley <[email protected]>

By default DEBUG_UART uses the SBI DBCN extension on S-Mode RISC-V platforms, but the Icicle Kit's firmware doesn't support it. Since DEBUG_UART is getting turned on automagically and this is somewhat misleading, disable it in the Icicle kit's defconfig.

---
CC: Conor Dooley <[email protected]>
CC: Cyril Jean <[email protected]>
CC: Tom Rini <[email protected]>
CC: Leo Yu-Chi Liang <[email protected]>
CC: [email protected]

Quoted 3 lines
---
 configs/microchip_mpfs_icicle_defconfig | 1 +
 1 file changed, 1 insertion(+)