Skip to contentSkip to conversation

arm64: dts: rockchip: Add reset button to NanoPi R5S

PATCH Applied Diederik de Haas 2 participants 2 messages Jul 11, 2025 – Jul 15, 2025

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH v2 1/1 arm64: dts: rockchip: Add reset button to NanoPi R5S

The NanoPi R5S LTS version has a reset button, which is connected via GPIO. Note that the non-LTS version does not have the reset button and therefore on page 19 of the schematic version 2204 it is marked 'NC', but it is connected on the LTS version.

---
Changes in v2:
- add 'pin' suffix to pinctrl nodes names/labels

 .../boot/dts/rockchip/rk3568-nanopi-r5s.dts   | 19 +++++++++++++++++++
 1 file changed, 19 insertions(+)
arch/arm64/boot/dts/rockchip/rk3568-nanopi-r5s.dts +19 -0
index 3b31f0dd8f3b..c12bd01e2805 100644
@@ -17,6 +17,19 @@ aliases {
 		ethernet0 = &gmac0;
 	};
 
+	gpio-keys {
+		compatible = "gpio-keys";
+		pinctrl-0 = <&gpio4_a0_k1_pin>;
+		pinctrl-names = "default";
+
+		button-reset {
+			debounce-interval = <50>;
+			gpios = <&gpio4 RK_PA0 GPIO_ACTIVE_LOW>;
+			label = "RESET";
+			linux,code = <KEY_RESTART>;
+		};
+	};
+
 	gpio-leds {
 		compatible = "gpio-leds";
 		pinctrl-names = "default";
@@ -127,6 +140,12 @@ eth_phy0_reset_pin: eth-phy0-reset-pin {
 		};
 	};
 
+	gpio-keys {
+		gpio4_a0_k1_pin: gpio4-a0-k1-pin {
+			rockchip,pins = <4 RK_PA0 RK_FUNC_GPIO &pcfg_pull_none>;
+		};
+	};
+
 	gpio-leds {
 		lan1_led_pin: lan1-led-pin {
 			rockchip,pins = <3 RK_PD6 RK_FUNC_GPIO &pcfg_pull_none>;
Signature · 1 line
2.50.0
maintainer Applied
#1 lore raw
Quoted 6 lines · Diederik de Haas

The NanoPi R5S LTS version has a reset button, which is connected via GPIO. Note that the non-LTS version does not have the reset button and therefore on page 19 of the schematic version 2204 it is marked 'NC', but it is connected on the LTS version.

Applied, thanks!

[1/1] arm64: dts: rockchip: Add reset button to NanoPi R5S

      commit: 954f07012794a3aa7ae89e56f070eaa1643af50b

Best regards,

Signature · 1 line
Heiko Stuebner <[email protected]>