riscv: dts: starfive: jh7110-common: drop no-sdio property from mmc1
Subsystems (3)
PATCH v2 1/1 riscv: dts: starfive: jh7110-common: drop no-sdio property from mmc1
Relax no-sdio restriction on mmc1 for jh7110 boards. Property was introduced for StarFive VisionFive2 dts to configure mmc1 for SD Card but this is not necessary, the restriction is only needed to block use of commands that would cause a device to malfunction.
--- arch/riscv/boot/dts/starfive/jh7110-common.dtsi | 1 - 1 file changed, 1 deletion(-)
arch/riscv/boot/dts/starfive/jh7110-common.dtsi +0 -1
@@ -290,7 +290,6 @@ &mmc1 { assigned-clock-rates = <50000000>; bus-width = <4>; bootph-pre-ram; - no-sdio; no-mmc; cd-gpios = <&sysgpio 41 GPIO_ACTIVE_LOW>; disable-wp;
base-commit: 038d61fd642278bab63ee8ef722c50d10ab01e8f
Signature · 1 line
2.50.0
Conor Dooley
maintainerQuoted 6 lines · E Shattow
Relax no-sdio restriction on mmc1 for jh7110 boards. Property was introduced for StarFive VisionFive2 dts to configure mmc1 for SD Card but this is not necessary, the restriction is only needed to block use of commands that would cause a device to malfunction.
Signed-off-by E Shattow <[email protected]>
I'm going to apply this one to for-next, to give it more of a chance to soak.
Quoted 21 lines
--- arch/riscv/boot/dts/starfive/jh7110-common.dtsi | 1 - 1 file changed, 1 deletion(-)arch/riscv/boot/dts/starfive/jh7110-common.dtsi +0
-1@@ -290,7 +290,6 @@ &mmc1 { assigned-clock-rates = <50000000>; bus-width = <4>; bootph-pre-ram; - no-sdio; no-mmc; cd-gpios = <&sysgpio 41 GPIO_ACTIVE_LOW>; disable-wp;base-commit:
038d61fd642278bab63ee8ef722c50d10ab01e8fSignature · 1 line
2.50.0
E, Conor.
That white boy you used to play paintball with.
Quoted 33 lines · Conor Dooley
Quoted 6 lines · E Shattow
Relax no-sdio restriction on mmc1 for jh7110 boards. Property was introduced for StarFive VisionFive2 dts to configure mmc1 for SD Card but this is not necessary, the restriction is only needed to block use of commands that would cause a device to malfunction.
Signed-off-by E Shattow <[email protected]>I'm going to apply this one to for-next, to give it more of a chance to soak.
Quoted 21 lines
--- arch/riscv/boot/dts/starfive/jh7110-common.dtsi | 1 - 1 file changed, 1 deletion(-)arch/riscv/boot/dts/starfive/jh7110-common.dtsi +0
-1@@ -290,7 +290,6 @@ &mmc1 { assigned-clock-rates = <50000000>; bus-width = <4>; bootph-pre-ram; - no-sdio; no-mmc; cd-gpios = <&sysgpio 41 GPIO_ACTIVE_LOW>; disable-wp;base-commit:
038d61fd642278bab63ee8ef722c50d10ab01e8f--
2.50.0