State of the UBI fastmap feature
Hello everyone,
after using UBI for almost 15 years now without fastmap, I'm currently experimenting with that feature. The help text in Kconfig menu (drivers/mtd/ubi/Kconfig) still says "Experimental feature" and further down:
Quoted 2 lines
Important: this feature is experimental so far and the on-flash format for fastmap may change in the next kernel versions
Is this still the current state? I can not remember seing any patches touching fastmap in the last time. Are there plans to stabilize this? Will there be changes in the on-flash format? Do folks even use this feature? In production?
Happy to get some opinions here.
Greets
Alex
Quoted 7 lines · Alexander Dahl
Hello everyone,
after using UBI for almost 15 years now without fastmap, I'm currently experimenting with that feature. The help text in
Kconfigmenu (drivers/mtd/ubi/Kconfig) still says "Experimental feature" and further down:
Quoted 7 lines
Quoted 2 lines
Important: this feature is experimental so far and the on-flash format for fastmap may change in the next kernel versions
Is this still the current state? I can not remember seing any patches touching fastmap in the last time. Are there plans to stabilize this? Will there be changes in the on-flash format? Do folks even use this feature? In production?
I don’t expect changes to the on-disk format, but the number of new raw NAND devices being introduced is now close to zero. As a result, the user base is very small,
and subtle bugs are likely to remain undiscovered.
Fastmap does have users, including in production,
but I don’t have concrete numbers. And I don't know their workload. That said, Fastmap should work but I still anticipate performance and runtime issues.
I guess your motivation is reducing the attach time?
Signature · 2 lines
Thanks, //richard
Hello Richard,
Am Tue, Sep 02, 2025 at 09:23:04AM +0200 schrieb Richard Weinberger:
Quoted 16 lines · Alexander Dahl
Quoted 7 lines
Hello everyone,
after using UBI for almost 15 years now without fastmap, I'm currently experimenting with that feature. The help text in
Kconfigmenu (drivers/mtd/ubi/Kconfig) still says "Experimental feature" and further down:Quoted 7 lines
Quoted 2 lines
Important: this feature is experimental so far and the on-flash format for fastmap may change in the next kernel versions
Is this still the current state? I can not remember seing any patches touching fastmap in the last time. Are there plans to stabilize this? Will there be changes in the on-flash format? Do folks even use this feature? In production?
Quoted 4 lines
I don’t expect changes to the on-disk format, but the number of new raw NAND devices being introduced is now close to zero. As a result, the user base is very small,
and subtle bugs are likely to remain undiscovered.
We are still using it in cost-sensitive products. Those raw NAND flash chips are a lot cheaper than eMMC or even NOR flashs of the same size.
Quoted 6 lines
Fastmap does have users, including in production,
but I don’t have concrete numbers. And I don't know their workload. That said, Fastmap should work but I still anticipate performance and runtime issues.I guess your motivation is reducing the attach time?
Indeed. Need to reduce boot time here, and UBI is attached twice. Once in U-Boot to read the kernel image and then again in Linux.
Greets
Alex
Quoted 4 lines · Alexander Dahl
Quoted 1 line
I guess your motivation is reducing the attach time?
Indeed. Need to reduce boot time here, and UBI is attached twice. Once in U-Boot to read the kernel image and then again in Linux.
Some ideas that could significantly improve attach time while being less invasive than Fastmap:
1. Pass the LEB-PEB mapping from U-Boot to Linux so that scanning occurs only in U-Boot.
2. Optimize EC/VID header reads:
2.1. If supported by the device, transfer only the actual header size instead of the entire (sub)page.
2.2. Read headers without ECC (if ECC overhead is measurable). If the header CRC fails, re-read with ECC.
Signature · 2 lines
Thanks, //richard