FAILED: patch "[PATCH] wifi: cfg80211: add an hrtimer based delayed work item" failed to apply to 6.12-stable tree

index 781624f5913a..820e299f06b5 100644
@@ -6435,6 +6435,11 @@ static inline void wiphy_delayed_work_init(struct wiphy_delayed_work *dwork,
  * after wiphy_lock() was called. Therefore, wiphy_cancel_work() can
  * use just cancel_work() instead of cancel_work_sync(), it requires
  * being in a section protected by wiphy_lock().
+ *
+ * Note that these are scheduled with a timer where the accuracy
+ * becomes less the longer in the future the scheduled timer is. Use
+ * wiphy_hrtimer_work_queue() if the timer must be not be late by more
+ * than approximately 10 percent.
  */
 void wiphy_delayed_work_queue(struct wiphy *wiphy,
 			      struct wiphy_delayed_work *dwork,

@@ -6506,6 +6511,79 @@ void wiphy_delayed_work_flush(struct wiphy *wiphy,
 bool wiphy_delayed_work_pending(struct wiphy *wiphy,
 				struct wiphy_delayed_work *dwork);
 
+struct wiphy_hrtimer_work {
+	struct wiphy_work work;
+	struct wiphy *wiphy;
+	struct hrtimer timer;
+};
+
+enum hrtimer_restart wiphy_hrtimer_work_timer(struct hrtimer *t);
+
+static inline void wiphy_hrtimer_work_init(struct wiphy_hrtimer_work *hrwork,
+					   wiphy_work_func_t func)
+{
+	hrtimer_setup(&hrwork->timer, wiphy_hrtimer_work_timer,
+		      CLOCK_BOOTTIME, HRTIMER_MODE_REL);
+	wiphy_work_init(&hrwork->work, func);
+}
+
+/**
+ * wiphy_hrtimer_work_queue - queue hrtimer work for the wiphy
+ * @wiphy: the wiphy to queue for
+ * @hrwork: the high resolution timer worker
+ * @delay: the delay given as a ktime_t
+ *
+ * Please refer to wiphy_delayed_work_queue(). The difference is that
+ * the hrtimer work uses a high resolution timer for scheduling. This
+ * may be needed if timeouts might be scheduled further in the future
+ * and the accuracy of the normal timer is not sufficient.
+ *
+ * Expect a delay of a few milliseconds as the timer is scheduled
+ * with some slack and some more time may pass between queueing the
+ * work and its start.
+ */
+void wiphy_hrtimer_work_queue(struct wiphy *wiphy,
+			      struct wiphy_hrtimer_work *hrwork,
+			      ktime_t delay);
+
+/**
+ * wiphy_hrtimer_work_cancel - cancel previously queued hrtimer work
+ * @wiphy: the wiphy, for debug purposes
+ * @hrtimer: the hrtimer work to cancel
+ *
+ * Cancel the work *without* waiting for it, this assumes being
+ * called under the wiphy mutex acquired by wiphy_lock().
+ */
+void wiphy_hrtimer_work_cancel(struct wiphy *wiphy,
+			       struct wiphy_hrtimer_work *hrtimer);
+
+/**
+ * wiphy_hrtimer_work_flush - flush previously queued hrtimer work
+ * @wiphy: the wiphy, for debug purposes
+ * @hrwork: the hrtimer work to flush
+ *
+ * Flush the work (i.e. run it if pending). This must be called
+ * under the wiphy mutex acquired by wiphy_lock().
+ */
+void wiphy_hrtimer_work_flush(struct wiphy *wiphy,
+			      struct wiphy_hrtimer_work *hrwork);
+
+/**
+ * wiphy_hrtimer_work_pending - Find out whether a wiphy hrtimer
+ * work item is currently pending.
+ *
+ * @wiphy: the wiphy, for debug purposes
+ * @hrwork: the hrtimer work in question
+ *
+ * Return: true if timer is pending, false otherwise
+ *
+ * Please refer to the wiphy_delayed_work_pending() documentation as
+ * this is the equivalent function for hrtimer based delayed work
+ * items.
+ */
+bool wiphy_hrtimer_work_pending(struct wiphy *wiphy,
+				struct wiphy_hrtimer_work *hrwork);
+
 /**
  * enum ieee80211_ap_reg_power - regulatory power for an Access Point
  *

62 lines not on this page · raw message

index 8a4c34112eb5..2b71f1d867a0 100644
@@ -304,6 +304,27 @@ TRACE_EVENT(wiphy_delayed_work_queue,
 		  __entry->delay)
 );
 
+TRACE_EVENT(wiphy_hrtimer_work_queue,
+	TP_PROTO(struct wiphy *wiphy, struct wiphy_work *work,
+		 ktime_t delay),
+	TP_ARGS(wiphy, work, delay),
+	TP_STRUCT__entry(
+		WIPHY_ENTRY
+		__field(void *, instance)
+		__field(void *, func)
+		__field(ktime_t, delay)
+	),
+	TP_fast_assign(
+		WIPHY_ASSIGN;
+		__entry->instance = work;
+		__entry->func = work->func;
+		__entry->delay = delay;
+	),
+	TP_printk(WIPHY_PR_FMT " instance=%p func=%pS delay=%llu",
+		  WIPHY_PR_ARG, __entry->instance, __entry->func,
+		  __entry->delay)
+);
+
 TRACE_EVENT(wiphy_work_worker_start,
 	TP_PROTO(struct wiphy *wiphy),
 	TP_ARGS(wiphy),

index c555d9964702c..96121dc14e826 100644
@@ -6105,6 +6105,11 @@ static inline void wiphy_delayed_work_init(struct wiphy_delayed_work *dwork,
  * after wiphy_lock() was called. Therefore, wiphy_cancel_work() can
  * use just cancel_work() instead of cancel_work_sync(), it requires
  * being in a section protected by wiphy_lock().
+ *
+ * Note that these are scheduled with a timer where the accuracy
+ * becomes less the longer in the future the scheduled timer is. Use
+ * wiphy_hrtimer_work_queue() if the timer must be not be late by more
+ * than approximately 10 percent.
  */
 void wiphy_delayed_work_queue(struct wiphy *wiphy,
 			      struct wiphy_delayed_work *dwork,

@@ -6176,6 +6181,79 @@ void wiphy_delayed_work_flush(struct wiphy *wiphy,
 bool wiphy_delayed_work_pending(struct wiphy *wiphy,
 				struct wiphy_delayed_work *dwork);
 
+struct wiphy_hrtimer_work {
+	struct wiphy_work work;
+	struct wiphy *wiphy;
+	struct hrtimer timer;
+};
+
+enum hrtimer_restart wiphy_hrtimer_work_timer(struct hrtimer *t);
+
+static inline void wiphy_hrtimer_work_init(struct wiphy_hrtimer_work *hrwork,
+					   wiphy_work_func_t func)
+{
+	hrtimer_init(&hrwork->timer, CLOCK_BOOTTIME, HRTIMER_MODE_REL);
+	hrwork->timer.function = wiphy_hrtimer_work_timer;
+	wiphy_work_init(&hrwork->work, func);
+}
+
+/**
+ * wiphy_hrtimer_work_queue - queue hrtimer work for the wiphy
+ * @wiphy: the wiphy to queue for
+ * @hrwork: the high resolution timer worker
+ * @delay: the delay given as a ktime_t
+ *
+ * Please refer to wiphy_delayed_work_queue(). The difference is that
+ * the hrtimer work uses a high resolution timer for scheduling. This
+ * may be needed if timeouts might be scheduled further in the future
+ * and the accuracy of the normal timer is not sufficient.
+ *
+ * Expect a delay of a few milliseconds as the timer is scheduled
+ * with some slack and some more time may pass between queueing the
+ * work and its start.
+ */
+void wiphy_hrtimer_work_queue(struct wiphy *wiphy,
+			      struct wiphy_hrtimer_work *hrwork,
+			      ktime_t delay);
+
+/**
+ * wiphy_hrtimer_work_cancel - cancel previously queued hrtimer work
+ * @wiphy: the wiphy, for debug purposes
+ * @hrtimer: the hrtimer work to cancel
+ *
+ * Cancel the work *without* waiting for it, this assumes being
+ * called under the wiphy mutex acquired by wiphy_lock().
+ */
+void wiphy_hrtimer_work_cancel(struct wiphy *wiphy,
+			       struct wiphy_hrtimer_work *hrtimer);
+
+/**
+ * wiphy_hrtimer_work_flush - flush previously queued hrtimer work
+ * @wiphy: the wiphy, for debug purposes
+ * @hrwork: the hrtimer work to flush
+ *
+ * Flush the work (i.e. run it if pending). This must be called
+ * under the wiphy mutex acquired by wiphy_lock().
+ */
+void wiphy_hrtimer_work_flush(struct wiphy *wiphy,
+			      struct wiphy_hrtimer_work *hrwork);
+
+/**
+ * wiphy_hrtimer_work_pending - Find out whether a wiphy hrtimer
+ * work item is currently pending.
+ *
+ * @wiphy: the wiphy, for debug purposes
+ * @hrwork: the hrtimer work in question
+ *
+ * Return: true if timer is pending, false otherwise
+ *
+ * Please refer to the wiphy_delayed_work_pending() documentation as
+ * this is the equivalent function for hrtimer based delayed work
+ * items.
+ */
+bool wiphy_hrtimer_work_pending(struct wiphy *wiphy,
+				struct wiphy_hrtimer_work *hrwork);
+
 /**
  * enum ieee80211_ap_reg_power - regulatory power for an Access Point
  *

62 lines not on this page · raw message

index 97c21b627791a..945013185c986 100644
@@ -304,6 +304,27 @@ TRACE_EVENT(wiphy_delayed_work_queue,
 		  __entry->delay)
 );
 
+TRACE_EVENT(wiphy_hrtimer_work_queue,
+	TP_PROTO(struct wiphy *wiphy, struct wiphy_work *work,
+		 ktime_t delay),
+	TP_ARGS(wiphy, work, delay),
+	TP_STRUCT__entry(
+		WIPHY_ENTRY
+		__field(void *, instance)
+		__field(void *, func)
+		__field(ktime_t, delay)
+	),
+	TP_fast_assign(
+		WIPHY_ASSIGN;
+		__entry->instance = work;
+		__entry->func = work->func;
+		__entry->delay = delay;
+	),
+	TP_printk(WIPHY_PR_FMT " instance=%p func=%pS delay=%llu",
+		  WIPHY_PR_ARG, __entry->instance, __entry->func,
+		  __entry->delay)
+);
+
 TRACE_EVENT(wiphy_work_worker_start,
 	TP_PROTO(struct wiphy *wiphy),
 	TP_ARGS(wiphy),