Skip to contentSkip to conversation

sync sdram ecc support to mainstream

PATCH In review Brian Sune 2 participants 4 messages Dec 15, 2025 – Jan 27

lore
Share & tools
lore

Brian Sune

author
#0 lore raw

PATCH 1/3 sync sdram ecc support to mainstream

It is been a while that the DDR ECC is missing.
Pull from Altera trunk and sync to mainstream.

---
 drivers/ddr/altera/Makefile | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)
drivers/ddr/altera/Makefile +2 -2
index 7ed43965be5..b9e3302d714 100644
@@ -7,8 +7,8 @@
 # Copyright (C) 2014-2025 Altera Corporation <www.altera.com>
 
 ifdef CONFIG_$(PHASE_)ALTERA_SDRAM
-obj-$(CONFIG_TARGET_SOCFPGA_GEN5) += sdram_gen5.o sequencer.o
-obj-$(CONFIG_TARGET_SOCFPGA_ARRIA10) += sdram_arria10.o
+obj-$(CONFIG_TARGET_SOCFPGA_GEN5) += sdram_soc32.o sdram_gen5.o sequencer.o
+obj-$(CONFIG_TARGET_SOCFPGA_ARRIA10) += sdram_soc32.o sdram_arria10.o
 obj-$(CONFIG_TARGET_SOCFPGA_STRATIX10) += sdram_soc64.o sdram_s10.o
 obj-$(CONFIG_TARGET_SOCFPGA_AGILEX) += sdram_soc64.o sdram_agilex.o
 obj-$(CONFIG_TARGET_SOCFPGA_N5X) += sdram_soc64.o sdram_n5x.o
Signature · 1 line
2.34.1
author
#1 lore raw

PATCH 2/3 sync sdram ecc support to mainstream

It is been a while that the DDR ECC is missing.
Pull from Altera trunk and sync to mainstream.
This sdram_soc32 introduce the ecc setup.
Modifications are done to support dts memory@0
while old memory will work properly on gd->bd
Real ECC supported board test is required.

---
 drivers/ddr/altera/sdram_soc32.c | 71 ++++++++++++++++++++++++++++++++
 drivers/ddr/altera/sdram_soc32.h | 11 +++++
 2 files changed, 82 insertions(+)
 create mode 100644 drivers/ddr/altera/sdram_soc32.c
 create mode 100644 drivers/ddr/altera/sdram_soc32.h
drivers/ddr/altera/sdram_soc32.c new file +71 -0
new file mode 100644
index 00000000000..e82146e448e
@@ -0,0 +1,71 @@
+// SPDX-License-Identifier: GPL-2.0
+/*
+ * Copyright (C) 2020 Intel Corporation <www.intel.com>
+ */
+
+#include <cpu_func.h>
+#include <dm.h>
+#include <asm/system.h>
+#include <linux/sizes.h>
+#include "sdram_soc32.h"
+#include <watchdog.h>
+#include <wait_bit.h>
+#if !defined(CONFIG_HW_WATCHDOG)
+#include <asm/arch/reset_manager.h>
+#endif
+
+#define PGTABLE_OFF	0x4000
+
+/* Initialize SDRAM ECC bits to avoid false DBE */
+void sdram_init_ecc_bits(unsigned long long sdram_size)
+{
+	u32 start;
+	phys_addr_t start_addr;
+	phys_size_t size, size_init;
+
+	start = get_timer(0);
+
+	start_addr = 0;
+	size = sdram_size;
+
+	printf("DDRCAL: Scrubbing ECC RAM (%ld MiB).\n", size >> 20);
+
+	memset((void *)start_addr, 0, PGTABLE_SIZE + PGTABLE_OFF);
+	start_addr += PGTABLE_SIZE + PGTABLE_OFF;
+	size -= PGTABLE_OFF + PGTABLE_SIZE;
+
+	dcache_enable();
+
+	while (size > 0) {
+		size_init = min((phys_addr_t)SZ_1G, (phys_addr_t)size);
+		memset((void *)start_addr, 0, size_init);
+		size -= size_init;
+		start_addr += size_init;
+
+		debug("%s: %d\n", __func__, __LINE__);
+
+#ifdef CONFIG_HW_WATCHDOG
+		/*
+		 * In case the watchdog is enabled,
+		 * make sure to (re-)configure watchdog
+		 * so that the defined timeout is valid.
+		 */
+		hw_watchdog_init();
+#else
+		/*
+		 * If the HW watchdog is NOT enabled,
+		 * make sure it is not running, because
+		 * it is enabled in the preloader and
+		 * causing boot loop if is not handled.
+		 */
+		socfpga_per_reset(SOCFPGA_RESET(L4WD0), 1);
+		socfpga_per_reset(SOCFPGA_RESET(L4WD0), 0);
+#endif
+	}
+
+	dcache_disable();
+
+	printf("DDRCAL: SDRAM-ECC initialized success with %d ms\n",
+	       (u32)get_timer(start));
+}
+
drivers/ddr/altera/sdram_soc32.h new file +11 -0
new file mode 100644
index 00000000000..7bd76eb560f
@@ -0,0 +1,11 @@
+/* SPDX-License-Identifier: GPL-2.0 */
+/*
+ * Copyright (C) 2020 Intel Corporation <www.intel.com>
+ */
+
+#ifndef	_SDRAM_SOC32_H_
+#define	_SDRAM_SOC32_H_
+
+void sdram_init_ecc_bits(unsigned long long sdram_size);
+
+#endif /* _SDRAM_SOC32_H_ */
Signature · 1 line
2.34.1
#2 lore raw

Hi Brian,

Quoted 9 lines · Brian Sune

[CAUTION: This email is from outside your organization. Unless you trust the sender, do not click on links or open attachments as it may be a fraudulent email attempting to steal your information and/or compromise your computer.]

It is been a while that the DDR ECC is missing. Pull from Altera trunk and sync to mainstream. This sdram_soc32 introduce the ecc setup. Modifications are done to support dts memory@0 while old memory will work properly on gd->bd Real ECC supported board test is required.

Quoted 7 lines
---
  drivers/ddr/altera/sdram_soc32.c | 71 ++++++++++++++++++++++++++++++++
  drivers/ddr/altera/sdram_soc32.h | 11 +++++
  2 files changed, 82 insertions(+)

create mode 100644 drivers/ddr/altera/sdram_soc32.c create mode 100644 drivers/ddr/altera/sdram_soc32.h

Thanks for working on this series patches.

This is covered by Alif’s more complete submission, so I’ll mark yours as superseded:

https://patchwork.ozlabs.org/project/uboot/cover/[email protected]/
If you spot gaps in Alif’s version, please add review comments or a follow-up patch.

Best regards,

Tien Fong

author
#3 lore raw

PATCH 3/3 sync sdram ecc support to mainstream

In reply to Brian Sune

It is been a while that the DDR ECC is missing. Pull from Altera trunk and sync to mainstream. Modifications are done to check ECC is on and only add necessary ECC code to SDRAM driver.

---
 drivers/ddr/altera/sdram_gen5.c | 15 +++++++++++++++
 1 file changed, 15 insertions(+)
drivers/ddr/altera/sdram_gen5.c +15 -0
index 3c79bb11802..07d8087fc7e 100644
@@ -19,6 +19,7 @@
 #include <dm/device_compat.h>
 
 #include "sequencer.h"
+#include "sdram_soc32.h"
 
 #ifdef CONFIG_XPL_BUILD
 
@@ -562,6 +563,12 @@ static unsigned long sdram_calculate_size(struct socfpga_sdr_ctrl *sdr_ctrl)
 	return temp;
 }
 
+static int sdram_is_ecc_enabled(struct socfpga_sdr_ctrl *sdr_ctrl)
+{
+	return !!(readl(&sdr_ctrl->ctrl_cfg) &
+		  SDR_CTRLGRP_CTRLCFG_ECCEN_MASK);
+}
+
 static int altera_gen5_sdram_of_to_plat(struct udevice *dev)
 {
 	struct altera_gen5_sdram_plat *plat = dev_get_plat(dev);
@@ -610,6 +617,14 @@ static int altera_gen5_sdram_probe(struct udevice *dev)
 		goto failed;
 	}
 
+	if (sdram_is_ecc_enabled(sdr_ctrl)) {
+		printf("DDR: ECC is enabled\n");
+		/* Must set USEECCASDATA to 0 if ECC is enabled */
+		clrbits_le32(&sdr_ctrl->static_cfg,
+			     SDR_CTRLGRP_STATICCFG_USEECCASDATA_MASK);
+		sdram_init_ecc_bits(sdram_size);
+	}
+
 	priv->info.base = 0;
 	priv->info.size = sdram_size;
 
Signature · 1 line
2.34.1