thermal: stm32: Use predefined HZ_PER_MHZ instead of a custom one
PATCH 1/1 thermal: stm32: Use predefined HZ_PER_MHZ instead of a custom one
Use predefined HZ_PER_MHZ instead of a custom one. No functional changes.
Signed-off-by Andy Shevchenko <[email protected]>
--- drivers/thermal/st/stm_thermal.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
drivers/thermal/st/stm_thermal.c +2 -2
@@ -16,6 +16,7 @@#include <linux/of.h> #include <linux/platform_device.h> #include <linux/thermal.h> +#include <linux/units.h> #include "../thermal_hwmon.h"
@@ -76,7 +77,6 @@/* Constants */ #define ADJUST 100 -#define ONE_MHZ 1000000#define POLL_TIMEOUT 5000#define STARTUP_TIME 40#define TS1_T0_VAL0 30000/* 30 celsius */
@@ -205,7 +205,7 @@ static int stm_thermal_calibration(struct stm_thermal_sensor *sensor)return -EINVAL ; prescaler =0 ; - clk_freq /=ONE_MHZ ; + clk_freq /=HZ_PER_MHZ ;if (clk_freq) {while (prescaler <= clk_freq) prescaler++;
Signature · 1 line
2.50.1
Daniel Lezcano
AppliedQuoted 4 lines · Andy Shevchenko
Use predefined
HZ_PER_MHZinstead of a custom one. No functional changes.Signed-off-by Andy Shevchenko <[email protected]>---
Applied, thanks
Signature · 5 lines
<http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs Follow Linaro: <http://www.facebook.com/pages/Linaro> Facebook | <http://twitter.com/#!/linaroorg> Twitter | <http://www.linaro.org/linaro-blog/> Blog