Skip to contentSkip to conversation

arm64: dts: ti: k3-am67a-kontron-sa67-base: fix QSPI flash timing

PATCH New Michael Walle 1 participant 1 message Jan 27

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 arm64: dts: ti: k3-am67a-kontron-sa67-base: fix QSPI flash timing

The boot flash is connected to the QSPI bus, but that bus is also connected to the edge connector. To prevent a stuck bus during boot. The signals to the edge connected are guarded by a FET switch. This FET switch needs a setup time of at least 80ns to disconnect the passthrough otherwise the first few clock cycles are still visible on the edge connector. Fix it by increasing the CS-to-clock timing to 120ns.

Fixes 1c3c4df06f9d ("arm64: dts: ti: Add support for Kontron SMARC-sAM67")
---
 arch/arm64/boot/dts/ti/k3-am67a-kontron-sa67-base.dts | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)
arch/arm64/boot/dts/ti/k3-am67a-kontron-sa67-base.dts +1 -1
index cdc9b5778041..9c0489514e04 100644
@@ -957,7 +957,7 @@ flash@0 {
 		cdns,tshsl-ns = <60>;
 		cdns,tsd2d-ns = <60>;
 		cdns,tchsh-ns = <60>;
-		cdns,tslch-ns = <60>;
+		cdns,tslch-ns = <120>;
 		cdns,read-delay = <3>;
 		vcc-supply = <&vcc_1p8_s0>;
 		bootph-all;
Signature · 1 line
2.47.3