dt-bindings: usb: st,st-ohci-300x: convert to DT schema
Subsystems (2)
PATCH v2 1/1 dt-bindings: usb: st,st-ohci-300x: convert to DT schema
Convert STMicroelectronics USB OHCI Controller binding to DT schema.
Signed-off-by Charan Pedumuru <[email protected]>
---
Changes in v2:
- Add "usb-hcd" as allOf reference.
- Remove minItems for the properties "clocks" and "resets".
- Link to v1: https://lore.kernel.org/r/[email protected]
--- Documentation/devicetree/bindings/usb/ohci-st.txt | 36 --------- .../devicetree/bindings/usb/st,st-ohci-300x.yaml | 85 ++++++++++++++++++++++ 2 files changed, 85 insertions(+), 36 deletions(-)
Documentation/devicetree/bindings/usb/ohci-st.txt deleted +0 -36
@@ -1,36 +0,0 @@ -ST USB OHCI controller - -Required properties: - - - compatible : must be "st,st-ohci-300x" - - reg : physical base addresses of the controller and length of memory mapped - region - - interrupts : one OHCI controller interrupt should be described here - - clocks : phandle list of usb clocks - - clock-names : should be "ic" for interconnect clock and "clk48" -See: Documentation/devicetree/bindings/clock/clock-bindings.txt - - - phys : phandle for the PHY device - - phy-names : should be "usb" - - - resets : phandle to the powerdown and reset controller for the USB IP - - reset-names : should be "power" and "softreset". -See: Documentation/devicetree/bindings/reset/st,stih407-powerdown.yaml -See: Documentation/devicetree/bindings/reset/reset.txt - -Example: - - ohci0: usb@fe1ffc00 { - compatible = "st,st-ohci-300x"; - reg = <0xfe1ffc00 0x100>; - interrupts = <GIC_SPI 149 IRQ_TYPE_NONE>; - clocks = <&clk_s_a1_ls 0>, - <&clockgen_b0 0>; - clock-names = "ic", "clk48"; - phys = <&usb2_phy>; - phy-names = "usb"; - - resets = <&powerdown STIH416_USB0_POWERDOWN>, - <&softreset STIH416_USB0_SOFTRESET>; - reset-names = "power", "softreset"; - };
Documentation/devicetree/bindings/usb/st,st-ohci-300x.yaml new file +85 -0
85 lines not on this page · raw message
---
base-commit: 4c87cdd0328495759f6e9f9f4e1e53ef8032a76f
change-id: 20260201-st-usb-f1348562ad65
Best regards,
Signature · 1 line
Charan Pedumuru <[email protected]>
Quoted 9 lines · Charan Pedumuru
Convert STMicroelectronics USB OHCI Controller binding to DT schema.
Signed-off-by Charan Pedumuru <[email protected]>---
Changes in v2:
- Add "usb-hcd" as allOf reference.
- Remove minItems for the properties "clocks" and "resets".
- Link to v1: https://lore.kernel.org/r/[email protected]
---
Looks good, thanks:
Reviewed-by Krzysztof Kozlowski <[email protected]>
Best regards,
Krzysztof