Skip to contentSkip to conversation

ahci: force 32-bit DMA for JMicron JMB582/JMB585

PATCH New Arthur Husband 1 participant 1 message Apr 3 libata

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 ahci: force 32-bit DMA for JMicron JMB582/JMB585

The JMicron JMB585 (and JMB582) SATA controllers advertise 64-bit DMA support via the S64A bit in the AHCI CAP register, but their 64-bit DMA implementation is defective. Under sustained I/O, DMA transfers targeting addresses above 4GB silently corrupt data — writes land at incorrect memory addresses with no errors logged.

This has been confirmed on multiple platforms (Minisforum N5 Pro, Raspberry Pi, Unraid, Proxmox, TrueNAS) and is consistent with the controller truncating or mishandling upper address bits during 64-bit DMA transactions.

The failure pattern is identical to the ASMedia ASM1062 (commit edb96a15dc18), which also falsely advertised 64-bit DMA and was fixed with AHCI_HFLAG_32BIT_ONLY.

On the Minisforum N5 Pro specifically, the combination of the JMB585's broken 64-bit DMA with the AMD Family 1Ah (Strix Point) IOMMU causes silent data corruption that is only detectable via checksumming filesystems (BTRFS/ZFS scrub). The corruption occurs when 32-bit IOVA space is exhausted and the kernel transparently switches to 64-bit DMA addresses.

Add device-specific PCI ID entries for the JMB582 (0x0582) and JMB585 (0x0585) before the generic JMicron class match, using a new board type that combines AHCI_HFLAG_IGN_IRQ_IF_ERR (preserving existing behavior) with AHCI_HFLAG_32BIT_ONLY to force 32-bit DMA masks.

Investigation and patch development assisted by Claude (Anthropic AI).

---
 drivers/ata/ahci.c | 16 +++++++++++++++-
 1 file changed, 15 insertions(+), 1 deletion(-)
drivers/ata/ahci.c +10 -0
index XXXXXXX..XXXXXXX 100644
@@ -51,6 +51,7 @@ enum board_ids {
 	board_ahci,
 	board_ahci_43bit_dma,
 	board_ahci_ign_iferr,
+	board_ahci_jmb585,
 	board_ahci_no_debounce_delay,
 	board_ahci_no_msi,
 	/*
@@ -115,6 +116,14 @@ static const struct ata_port_info ahci_port_info[] = {
 		.udma_mask	= ATA_UDMA6,
 		.port_ops	= &ahci_ops,
 	},
+	/* JMicron JMB582/585: 64-bit DMA is broken, force 32-bit */
+	[board_ahci_jmb585] = {
+		AHCI_HFLAGS	(AHCI_HFLAG_IGN_IRQ_IF_ERR |
+				 AHCI_HFLAG_32BIT_ONLY),
+		.flags		= AHCI_FLAG_COMMON,
+		.pio_mask	= ATA_PIO4,
+		.udma_mask	= ATA_UDMA6,
+		.port_ops	= &ahci_ops,
+	},
 	[board_ahci_no_debounce_delay] = {
 		.flags		= AHCI_FLAG_COMMON,

.link_flags = ATA_LFLAG_NO_DEBOUNCE_DELAY,
@@ -XXX,7 +XXX,12 @@ static const struct pci_device_id ahci_pci_tbl[] = {
...

- /* JMicron 360/1/3/5/6, match class to avoid IDE function */
+ /* JMicron JMB582/585: force 32-bit DMA (broken 64-bit implementation) */
+ { PCI_VDEVICE(JMICRON, 0x0582), board_ahci_jmb585 },
+ { PCI_VDEVICE(JMICRON, 0x0585), board_ahci_jmb585 },
+
+ /* JMicron 360/1/3/5/6, match class to avoid IDE function */
{ PCI_VENDOR_ID_JMICRON, PCI_ANY_ID, PCI_ANY_ID, PCI_ANY_ID,
PCI_CLASS_STORAGE_SATA_AHCI, 0xffffff, board_ahci_ign_iferr },

--