Skip to contentSkip to conversation

scsi: sr: propagate read-only status to block layer via set_disk_ro()

PATCH RESEND Superseded Daan De Meyer 1 participant 1 message Apr 15 SCSI

v1 of 2 Superseded Latest is v2 →

lore
Share & tools
lore
#0 lore raw

PATCH RESEND 1/1 scsi: sr: propagate read-only status to block layer via set_disk_ro()

The sr driver tracks whether a CD-ROM drive supports writing via the cd->writeable flag, which is determined from the drive's MODE SENSE capabilities page (page 0x2A). When the drive does not report any write capabilities (CD-RW, DVD-RAM, etc.), writeable is supposed to remain 0 and write requests are rejected in sr_init_command().

However, this information is never propagated to the block layer via set_disk_ro(). As a result, BLKROGET on a CD-ROM device always returns 0 (writable), even when the drive has no write capabilities and writes will inevitably fail. This causes problems for userspace that relies on BLKROGET to determine whether a block device is read-only. For example, systemd's loop device setup uses BLKROGET to decide whether to create a loop device with LO_FLAGS_READ_ONLY. Without the read-only flag, writes pass through the loop device to the CD-ROM and fail with I/O errors. systemd-fsck similarly checks BLKROGET to decide whether to run fsck in no-repair mode (-n).

The sd driver (SCSI disks) does not have this problem because it checks the MODE SENSE Write Protect bit and calls set_disk_ro() accordingly. The sr driver cannot use the same approach because the MMC specification does not define the WP bit in the MODE SENSE device-specific parameter byte for CD-ROM devices.

Fix this by calling set_disk_ro(disk, !cd->writeable) in sr_probe() after get_capabilities() has determined the drive's write support.

Fixes 1da177e4c3f4 ("Linux-2.6.12-rc2")
---
 drivers/scsi/sr.c | 1 +
 1 file changed, 1 insertion(+)
drivers/scsi/sr.c +1 -0
index 7adb2573f50d..8ed002f82e36 100644
@@ -684,6 +684,7 @@ static int sr_probe(struct scsi_device *sdev)
 	sr_vendor_init(cd);
 
 	set_capacity(disk, cd->capacity);
+	set_disk_ro(disk, !cd->writeable);
 	disk->private_data = cd;
 
 	if (register_cdrom(disk, &cd->cdi))
Signature · 1 line
2.53.0