dt-bindings: iio: adc: add AD7816/AD7817/AD7818 binding

new file mode 100644
index 000000000000..490e5338d7b2
@@ -0,0 +1,94 @@
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/iio/adc/adi,ad7816.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: Analog Devices AD7816/AD7817/AD7818 ADC
+
+maintainers:
+  - Hungyu Lin <[email protected]>
+
+description: |
+  Binding for Analog Devices AD7816, AD7817 and AD7818 SPI ADCs
+  with on-chip temperature sensor.
+
+  The AD7816 provides temperature monitoring only.
+  The AD7817 provides up to 4 analog input channels.
+  The AD7818 provides a single analog input channel.
+
+properties:
+  compatible:
+    enum:
+      - adi,ad7816
+      - adi,ad7817
+      - adi,ad7818
+
+  reg:
+    maxItems: 1
+
+  interrupts:
+    maxItems: 1
+    description:
+      Optional interrupt line used by the device.
+
+  rdwr-gpios:
+    maxItems: 1
+    description:
+      GPIO connected to the RD/WR pin used to control read/write cycles.
+
+  convert-gpios:
+    maxItems: 1
+    description:
+      GPIO connected to the CONVST pin used to trigger conversions.
+
+  busy-gpios:
+    maxItems: 1
+    description:
+      GPIO connected to the BUSY pin indicating conversion status.
+
+required:
+  - compatible
+  - reg
+  - rdwr-gpios
+  - convert-gpios
+
+allOf:
+  - $ref: /schemas/spi/spi-peripheral-props.yaml#
+
+  - if:
+      properties:
+        compatible:
+          contains:
+            enum:
+              - adi,ad7816
+              - adi,ad7817
+    then:
+      required:
+        - busy-gpios
+    else:
+      properties:
+        busy-gpios: false
+
+unevaluatedProperties: false
+
+examples:
+  - |
+    gpio0: gpio {
+      gpio-controller;
+      #gpio-cells = <2>;
+    };
+
+    spi {
+      #address-cells = <1>;
+      #size-cells = <0>;
+
+      adc@0 {
+        compatible = "adi,ad7816";
+        reg = <0>;
+        spi-max-frequency = <5000000>;
+        rdwr-gpios = <&gpio0 1 0>;
+        convert-gpios = <&gpio0 2 0>;
+        busy-gpios = <&gpio0 3 0>;
+      };
+    };