x86/svm: add comprehensive tests for GMET
PATCH 1/1 x86/svm: add comprehensive tests for GMET
Enhancements:
- Improve code comments on all GMET tests explaining the setup rationale and polishing up here and there.
- Update npt_prepare_gmet_pte() comment in svm.c to document GMET U-bit semantics (U=0 allows, U=1 traps).
- Add report_info() calls to every GMET check function logging exit_code, exit_info_1, and expected values so failures are immediately diagnosable from test output.
New tests:
- npt_gmet_rw: verify GMET does not affect data reads/writes (U=0 data page with GMET enabled should succeed).
- npt_gmet_ring3: verify user-mode (ring 3) instruction fetches are not affected by GMET regardless of the NPT U bit, similar to the MBEC OP_EXEC_USER -> run_in_user() behavior.
- npt_gmet_large: verify GMET traps on a 2M large page with U=1.
- gmet_transition_v2: verify GMET on/off transitions with U=1 code.
- gmet_matrix_v2: systematic NX/U/access-type permission matrix.
--- x86/svm.c | 9 +- x86/svm_npt.c | 384 ++++++++++++++++++++++++++++++++++++++++++++++++++ 2 files changed, 389 insertions(+), 4 deletions(-)
x86/svm.c +5 -4
@@ -43,6 +43,11 @@ u64 *npt_get_pml4e(void)return pml4e; } +/* +* Set or clear the NPT U bit on the 2 MiB code region. With GMET enabled, +* U=0 allows supervisor instruction fetches and U=1 traps them (#NPF). +* GMET does not affect data accesses, so page table walks ignore U. +*/ void npt_prepare_gmet_pte (bool user) {extern u8 start;
@@ -51,10 +56,6 @@ void npt_prepare_gmet_pte(bool user)u64 *pte;int i; - -/* flip the U bit on the 2 MiB region where the code is loaded. -* the U bit is only used for execution, therefore page table accesses ignore it -*/ pte =npt_get_pte (address);for (i =0 ; i <512 ; i++) pte[i] = (pte[i] & ~PT_USER_MASK ) | mask;
x86/svm_npt.c +384 -0
426 lines not on this page · raw message
Signature · 1 line
2.43.0