Skip to contentSkip to conversation

Input: synaptics - retry SMBus intertouch setup when companion is not ready

PATCH In review Raphaël Larocque 2 participants 2 messages Jun 3

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Input: synaptics - retry SMBus intertouch setup when companion is not ready

On some machines (here: Lenovo ThinkPad T440p 20AWS0H800), the SMBus companion device is not ready
by the time psmouse probes the Synaptics touchpad
during early boot. synaptics_setup_intertouch() returns -EAGAIN in this situation, but synaptics_init() previously treated this the same as any other error and fell through immediately to PS/2 mode. As a result, the touchpad and TrackPoint were unresponsive for several minutes after a cold boot, until an internal reconnect cycle (which already carries retry logic in synaptics_reconnect()) eventually succeeded.

Fix this by adding an exponential back-off retry loop in synaptics_init() when synaptics_setup_intertouch() returns -EAGAIN: clean up the failed state, sleep for 500 ms on the first attempt doubling each time up to 4000 ms, then retry. The worst-case added latency at boot is ~7.5 s (500 + 1000 + 2000 + 4000 ms), and only for hardware that actually reports SYN_CAP_INTERTOUCH. The pattern mirrors what synaptics_reconnect() already does after resume.

---
 drivers/input/mouse/synaptics.c | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)
drivers/input/mouse/synaptics.c +17 -0
index c70502e24031..5c1bfff2b16c 100644
@@ -1918,6 +1918,23 @@ int synaptics_init(struct psmouse *psmouse)
 		}
 
 		error = synaptics_setup_intertouch(psmouse, &info, true);
+		if (error == -EAGAIN) {
+			/*
+			 * On some systems (e.g. ThinkPad T440p) the SMBus
+			 * companion device is not yet ready at boot time.
+			 * Clean up and retry with exponential back-off,
+			 * mirroring synaptics_reconnect().
+			 */
+			unsigned int delay = 500;
+
+			do {
+				psmouse_smbus_cleanup(psmouse);
+				msleep(delay);
+				error = synaptics_setup_intertouch(psmouse, &info, true);
+				delay *= 2;
+			} while (error == -EAGAIN && delay <= 4000);
+		}
+
 		if (!error)
 			return PSMOUSE_SYNAPTICS_SMBUS;
 	}
Signature · 1 line
2.53.0
maintainer
#1 lore raw

Hi Raphaël,

Quoted 40 lines · Raphaël Larocque

On some machines (here: Lenovo ThinkPad T440p 20AWS0H800), the SMBus companion device is not ready
by the time psmouse probes the Synaptics touchpad
during early boot. synaptics_setup_intertouch() returns -EAGAIN in this situation, but synaptics_init() previously treated this the same as any other error and fell through immediately to PS/2 mode. As a result, the touchpad and TrackPoint were unresponsive for several minutes after a cold boot, until an internal reconnect cycle (which already carries retry logic in synaptics_reconnect()) eventually succeeded.

Fix this by adding an exponential back-off retry loop in synaptics_init() when synaptics_setup_intertouch() returns -EAGAIN: clean up the failed state, sleep for 500 ms on the first attempt doubling each time up to 4000 ms, then retry. The worst-case added latency at boot is ~7.5 s (500 + 1000 + 2000 + 4000 ms), and only for hardware that actually reports SYN_CAP_INTERTOUCH. The pattern mirrors what synaptics_reconnect() already does after resume.

---
 drivers/input/mouse/synaptics.c | 17 +++++++++++++++++
 1 file changed, 17 insertions(+)
drivers/input/mouse/synaptics.c +7 -0
index c70502e24031..5c1bfff2b16c 100644
@@ -1918,6 +1918,23 @@ int synaptics_init(struct psmouse *psmouse)
 		}
 
 		error = synaptics_setup_intertouch(psmouse, &info, true);
+		if (error == -EAGAIN) {
+			/*
+			 * On some systems (e.g. ThinkPad T440p) the SMBus
+			 * companion device is not yet ready at boot time.
+			 * Clean up and retry with exponential back-off,
+			 * mirroring synaptics_reconnect().
+			 */

drivers/input/mouse/synaptics.c int synaptics_init(struct psmouse *psmouse) · line 1937

Quoted 10 lines
drivers/input/mouse/synaptics.c +10 -0
+			unsigned int delay = 500;
+
+			do {
+				psmouse_smbus_cleanup(psmouse);
+				msleep(delay);
+				error = synaptics_setup_intertouch(psmouse, &info, true);
+				delay *= 2;
+			} while (error == -EAGAIN && delay <= 4000);
+		}
+

The idea here is that if adapter/device is not ready we leave enuough "breadcumbs" for it to recognize when SMBus companion appears and complete the initialization without repeatedly cleaning up and retrying initialization anew.

Could you enable logging and see where the logic fails for you? I am not too keen on simply adding up to 8 seconds delay to the boot time.

Thanks.

Signature · 1 line
Dmitry