arm64: dts: nuvoton: ma35d1: add CAN nodes
PATCH v2 1/1 arm64: dts: nuvoton: ma35d1: add CAN nodes
Add controller nodes for the four Bosch M_CAN blocks found on the Nuvoton MA35D1 SoC.
Additionally, configure pinctrl and enable CAN1 and CAN3 on the MA35D1 SOM board. Also, update the APLL frequency to 200MHz to ensure the CAN controllers receive the required input clock for 50MHz operation.
Signed-off-by Zi-Yu Chen <[email protected]>
---
v2:
- Move assigned-clocks and assigned-clock-rates configurations of CAN_DIV from SoC-level ma35d1.dtsi to board-level ma35d1-som-256m.dts
- Update APLL frequency to 200MHz to ensure the CAN controllers receive the required 50MHz input clock.
.../boot/dts/nuvoton/ma35d1-som-256m.dts | 32 +++++++++++- arch/arm64/boot/dts/nuvoton/ma35d1.dtsi | 52 +++++++++++++++++++ 2 files changed, 83 insertions(+), 1 deletion(-)
arch/arm64/boot/dts/nuvoton/ma35d1-som-256m.dts +31 -1
@@ -37,6 +37,22 @@ clk_hxt: clock-hxt { }; }; +&can1 { + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_can1>; + assigned-clocks = <&clk CAN1_DIV>; + assigned-clock-rates = <50000000>; + status = "okay"; +}; + +&can3 { + pinctrl-names = "default"; + pinctrl-0 = <&pinctrl_can3>; + assigned-clocks = <&clk CAN3_DIV>; + assigned-clock-rates = <50000000>; + status = "okay"; +}; + &clk { assigned-clocks = <&clk CAPLL>, <&clk DDRPLL>,
@@ -45,7 +61,7 @@ &clk { <&clk VPLL>; assigned-clock-rates = <800000000>, <266000000>, - <180000000>, + <200000000>, <500000000>, <102000000>; nuvoton,pll-mode = "integer",
@@ -56,6 +72,20 @@ &clk { }; &pinctrl { + can-grp { + pinctrl_can1: can1-pins { + nuvoton,pins = <11 14 4>, + <11 15 4>; + bias-disable; + }; + + pinctrl_can3: can3-pins { + nuvoton,pins = <11 10 3>, + <11 11 3>; + bias-disable; + }; + }; + uart-grp { pinctrl_uart0: uart0-pins { nuvoton,pins = <4 14 1>,
arch/arm64/boot/dts/nuvoton/ma35d1.dtsi +52 -0
58 lines not on this page · raw message
Signature · 1 line
2.34.1