Skip to contentSkip to conversation

arm64: dts: imx95-var-dart: wm8904: Add INL1 as DMICDAT1

PATCH Applied Stefano Radaelli 2 participants 2 messages Jul 1 – Jul 6

Subsystems (2)
lore
Share & tools
lore
#0 lore raw

PATCH 1/1 arm64: dts: imx95-var-dart: wm8904: Add INL1 as DMICDAT1

From: Stefano Radaelli <[email protected]>

On the DART-MX95 platform, INL1/DMICDAT1 is used as the DMIC data line.

Add the wlf,in1l-as-dmicdat1 property to reflect this configuration. This enables the internal MUX to switch between the ADC and DMIC as the capture input.

---
 arch/arm64/boot/dts/freescale/imx95-var-dart.dtsi | 2 ++
 1 file changed, 2 insertions(+)
arch/arm64/boot/dts/freescale/imx95-var-dart.dtsi +2 -0
index a20fadacaa6d..d43270a1d907 100644
@@ -158,6 +158,8 @@ wm8904: audio-codec@1a {
 				   /bits/ 16 <0x04af 0x324b 0x0010 0x050e>;
 		/* GPIO1 = DMIC_CLK, don't touch others */
 		wlf,gpio-cfg = <0x0018>, <0xffff>, <0xffff>, <0xffff>;
+		/* DMIC is connected to IN1L */
+		wlf,in1l-as-dmicdat1;
 	};
 };
 
Signature · 1 line
2.47.3
#1 lore raw

From: Frank Li <[email protected]>

Quoted 8 lines · Stefano Radaelli

On the DART-MX95 platform, INL1/DMICDAT1 is used as the DMIC data line.

Add the wlf,in1l-as-dmicdat1 property to reflect this configuration. This enables the internal MUX to switch between the ADC and DMIC as the capture input.

[...]

Applied, thanks!

[1/1] arm64: dts: imx95-var-dart: wm8904: Add INL1 as DMICDAT1

      commit: 68427905850302612bd68dcec7baf791ca6f8032

Best regards,

Signature · 1 line
Frank Li <[email protected]>