staging: media: ipu7: fix pm_runtime refcount leaks
Subsystems (3)
cover staging: media: ipu7: fix pm_runtime refcount leaks
pm_runtime_get_sync() is used in two places in the ipu7 driver before accessing the device. If runtime PM resume fails, the usage count remains incremented, but both error paths return without dropping the reference.
Use pm_runtime_resume_and_get() instead, which balances the usage count on failure and avoids the leaked runtime PM references. This matches the equivalent code in the ipu6 driver.
Vidhu Sarwal (2):
staging: media: ipu7: fix pm_runtime refcount leak in
ipu7_init_fw_code_region_by_sys()
staging: media: ipu7: fix pm_runtime refcount leak in ipu7_resume()
drivers/staging/media/ipu7/ipu7.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
Signature · 1 line
2.53.0
PATCH 1/2 staging: media: ipu7: fix pm_runtime refcount leak in ipu7_init_fw_code_region_by_sys()
ipu7_init_fw_code_region_by_sys() calls pm_runtime_get_sync() before accessing the firmware code region. If resuming the device fails, pm_runtime_get_sync() leaves the runtime PM usage count incremented, but the error path returns without dropping the reference.
Use pm_runtime_resume_and_get() instead, which balances the usage count automatically on failure and avoids the leak.
The ipu6 driver uses pm_runtime_resume_and_get() in the equivalent location.
--- drivers/staging/media/ipu7/ipu7.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
drivers/staging/media/ipu7/ipu7.c +1 -1
@@ -2343,7 +2343,7 @@ static int ipu7_init_fw_code_region_by_sys(struct ipu7_bus_device *sys,return ret; } - ret =pm_runtime_get_sync (dev); + ret =pm_runtime_resume_and_get (dev);if (ret <0 ) {dev_err (dev,"Failed to get runtime PM\n" );return ret;
Signature · 1 line
2.53.0
PATCH 2/2 staging: media: ipu7: fix pm_runtime refcount leak in ipu7_resume()
In reply to Vidhu Sarwalipu7_resume() calls pm_runtime_get_sync() before resuming the device. If the runtime PM resume fails, the usage count remains incremented, but the error path returns without dropping the reference.
Use pm_runtime_resume_and_get() instead, which balances the usage count on failure and avoids the leak. Keep returning 0 on error, as resume callbacks should not propagate failures to the PM core, matching the behaviour of the ipu6 driver.
--- drivers/staging/media/ipu7/ipu7.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
drivers/staging/media/ipu7/ipu7.c +1 -1
@@ -2702,7 +2702,7 @@ static int ipu7_resume(struct device *dev)if (ret)dev_err (dev,"IPC reset protocol failed!\n" ); - ret =pm_runtime_get_sync (&isp->psys->auxdev.dev); + ret =pm_runtime_resume_and_get (&isp->psys->auxdev.dev);if (ret <0 ) {dev_err (dev,"Failed to get runtime PM\n" );return 0 ;
Signature · 1 line
2.53.0