sysreset: esp32: add driver for esp32 series chips
PATCH 1/1 sysreset: esp32: add driver for esp32 series chips
From: Honbo He <[email protected]>
Add system reset driver for Espressif Gen3 and Gen4 RISC-V SoCs. The reset register base address, offset, and bit mask are read from the device tree to support different chip variants without code changes.
--- drivers/sysreset/Kconfig | 9 ++++ drivers/sysreset/Makefile | 1 + drivers/sysreset/sysreset_esp32.c | 72 +++++++++++++++++++++++++++++++ 3 files changed, 82 insertions(+) create mode 100644 drivers/sysreset/sysreset_esp32.c
drivers/sysreset/Kconfig +9 -0
@@ -64,6 +64,15 @@ config SYSRESET_CV1800B help Enable system reset support for Sophgo cv1800b SoC. +config SYSRESET_ESP32 + bool "Enable support for Espressif esp32 System Reset" + help + Enable system reset support for Espressif Gen3 and Gen4 + SoCs (C5, C6, C61, H2, H21, H4, P4, S31) Reset register parameters + are configured via device tree. + Gen1/Gen2 chips (ESP32, S2, S3, C2, C3) are not supported + as they rely on the boot ROM for system reset. + config POWEROFF_GPIO bool "Enable support for GPIO poweroff driver" depends on DM_GPIO
drivers/sysreset/Makefile +1 -0
@@ -33,3 +33,4 @@ obj-$(CONFIG_SYSRESET_RAA215300) += sysreset_raa215300.o obj-$(CONFIG_SYSRESET_QCOM_PSHOLD) += sysreset_qcom-pshold.o obj-$(CONFIG_TARGET_XTFPGA) += sysreset_xtfpga.o obj-$(CONFIG_SYSRESET_QEMU_VIRT_CTRL) += sysreset_qemu_virt_ctrl.o +obj-$(CONFIG_SYSRESET_ESP32) += sysreset_esp32.o
drivers/sysreset/sysreset_esp32.c new file +72 -0
72 lines not on this page · raw message
Signature · 1 line
2.34.1
Quoted 14 lines · On Sun, Jul 12, 2026 at 03:48:16PM +0800, [email protected] wrote:
From: Honbo He <[email protected]>
Add system reset driver for Espressif Gen3 and Gen4 RISC-V SoCs. The reset register base address, offset, and bit mask are read from the device tree to support different chip variants without code changes.
Signed-off-by Honbo He <[email protected]>--- drivers/sysreset/Kconfig | 9 ++++ drivers/sysreset/Makefile | 1 + drivers/sysreset/sysreset_esp32.c | 72 +++++++++++++++++++++++++++++++ 3 files changed, 82 insertions(+) create mode 100644 drivers/sysreset/sysreset_esp32.c
...
Quoted 15 lines
drivers/sysreset/sysreset_esp32.c new file +9
-0@@ -0,0 +1,72 @@ +// SPDX-License-Identifier: GPL-2.0+ +/* +* Copyright (C) 2026, Honbo He <[email protected]> +* +* System reset driver for Espressif SoCs. +* +* Supported SoCs (Gen3/4): +* ESP32-C5, ESP32-C6, ESP32-C61, ESP32-H2, ESP32-H21, ESP32-H4, +* ESP32-P4, ESP32-S31
drivers/sysreset/sysreset_esp32.c line 19
Quoted 10 lines
drivers/sysreset/sysreset_esp32.c new file +10
-0+* +* On the unsupported chips(Gen1/2), the system reset logic resides inside the +* RTC_CNTL peripheral and is only accessible through the boot ROM function +* software_reset_cpu(). The register definitions are not exposed in the SoC headers, +* making it impractical to implement a direct register-based reset +* in U-Boot without reverse-engineering the ROM code. +*/ + +#include <dm.h> +#include <stdbool.h>
But you make no use of bool, so I guess this could be ommitted
drivers/sysreset/sysreset_esp32.c line 21
Quoted 2 lines
drivers/sysreset/sysreset_esp32.c new file +2
-0+#include <sysreset.h> +#include <wait_bit.h>
Not used, either.
drivers/sysreset/sysreset_esp32.c line 23
Quoted 2 lines
drivers/sysreset/sysreset_esp32.c new file +2
-0+#include <linux/io.h> +#include <linux/errno.h>
Could you please sort the headers, too?
drivers/sysreset/sysreset_esp32.c line 35
Quoted 12 lines
drivers/sysreset/sysreset_esp32.c new file +12
-0+ +struct esp32_sysreset_priv { +void __iomem *base; +u32 offset; +u32 mask; +}; + +static int esp32_sysreset_request (struct udevice *dev,enum sysreset_t type) +{ +struct esp32_sysreset_priv *priv =dev_get_priv (dev); + +setbits_le32 (priv->base + priv->offset, priv->mask);
And this looks quite compatible with the generic syscon-reboot binding. Why not re-use this driver instead?
Quoted 16 lines
drivers/sysreset/sysreset_esp32.c new file +16
-0+ +return -EINPROGRESS ; +} + +static struct sysreset_ops esp32_sysreset = { + .request = esp32_sysreset_request, +}; + +static int esp32_sysreset_probe (struct udevice *dev) +{ +struct esp32_sysreset_priv *priv =dev_get_priv (dev); + + priv->base =dev_read_addr_ptr (dev); +if (!priv->base) +return -EINVAL ; +
drivers/sysreset/sysreset_esp32.c line 61
Quoted 10 lines
drivers/sysreset/sysreset_esp32.c new file +10
-0+ priv->offset =dev_read_u32_default (dev,"offset" ,0 ); + priv->mask =dev_read_u32_default (dev,"mask" ,0 ); +if (priv->mask ==0 ) +return -EINVAL ; + +return 0 ; +} + +static const struct udevice_id esp32s31_sysreset_ids[] = { + { .compatible ="esp,esp32-sysreset" , },
Is the compatible documented anywhere so we could have a stable dt ABI as reference? I searched current Linux master but got no luck.
Best regards,
Yao Zi