staging: rtl8723bs: remove unnecessary braces

index a364f4507..7862cea83 100644
@@ -194,9 +194,9 @@ static s32 polling_fwdl_chksum(
 		yield();
 	} while (jiffies_to_msecs(jiffies-start) < timeout_ms || cnt < min_cnt);
 
-	if (!(value32 & FWDL_ChkSum_rpt)) {
+	if (!(value32 & FWDL_ChkSum_rpt))
 		goto exit;
-	}
+
 
 	if (g_fwdl_chksum_fail) {
 		g_fwdl_chksum_fail--;

@@ -235,9 +235,9 @@ static s32 _FWFreeToGo(struct adapter *adapter, u32 min_cnt, u32 timeout_ms)
 		yield();
 	} while (jiffies_to_msecs(jiffies - start) < timeout_ms || cnt < min_cnt);
 
-	if (!(value32 & WINTINI_RDY)) {
+	if (!(value32 & WINTINI_RDY))
 		goto exit;
-	}
+
 
 	if (g_fwdl_wintint_rdy_fail) {
 		g_fwdl_wintint_rdy_fail--;

@@ -1031,9 +1031,9 @@ void UpdateHalRAMask8723B(struct adapter *padapter, u32 mac_id, u8 rssi_level)
 	rate_bitmap = hal_btcoex_GetRaMask(padapter);
 	mask &= ~rate_bitmap;
 
-	if (pHalData->fw_ractrl) {
+	if (pHalData->fw_ractrl)
 		rtl8723b_set_FwMacIdConfig_cmd(padapter, mac_id, psta->raid, psta->bw_mode, short_gi_rate, mask);
-	}
+
 
 	/* set correct initial date rate for each mac_id */
 	pdmpriv->INIDATA_RATE[mac_id] = psta->init_rate;

@@ -1184,9 +1184,9 @@ void Hal_EfuseParseIDCode(struct adapter *padapter, u8 *hwinfo)
 
 	/*  Check 0x8129 again for making sure autoload status!! */
 	EEPROMId = le16_to_cpu(*((__le16 *)hwinfo));
-	if (EEPROMId != RTL_EEPROM_ID) {
+	if (EEPROMId != RTL_EEPROM_ID)
 		pEEPROM->bautoload_fail_flag = true;
-	} else
+	else
 		pEEPROM->bautoload_fail_flag = false;
 }
 

@@ -1566,13 +1566,13 @@ u8 SCMapping_8723B(struct adapter *Adapter, struct pkt_attrib *pattrib)
 		if (pattrib->bwmode == CHANNEL_WIDTH_40) {
 			SCSettingOfDesc = HT_DATA_SC_DONOT_CARE;
 		} else if (pattrib->bwmode == CHANNEL_WIDTH_20) {
-			if (pHalData->nCur40MhzPrimeSC == HAL_PRIME_CHNL_OFFSET_UPPER) {
+			if (pHalData->nCur40MhzPrimeSC == HAL_PRIME_CHNL_OFFSET_UPPER)
 				SCSettingOfDesc = HT_DATA_SC_20_UPPER_OF_40MHZ;
-			} else if (pHalData->nCur40MhzPrimeSC == HAL_PRIME_CHNL_OFFSET_LOWER) {
+			else if (pHalData->nCur40MhzPrimeSC == HAL_PRIME_CHNL_OFFSET_LOWER)
 				SCSettingOfDesc = HT_DATA_SC_20_LOWER_OF_40MHZ;
-			} else {
+			else
 				SCSettingOfDesc = HT_DATA_SC_DONOT_CARE;
-			}
+
 		}
 	} else {
 		SCSettingOfDesc = HT_DATA_SC_DONOT_CARE;

@@ -1596,9 +1596,9 @@ static void rtl8723b_cal_txdesc_chksum(struct tx_desc *ptxdesc)
 	/*  Thomas, Lucas@SD4, 20130515 */
 	count = 16;
 
-	for (index = 0; index < count; index++) {
+	for (index = 0; index < count; index++)
 		checksum |= le16_to_cpu(*(__le16 *)(usPtr + index));
-	}
+
 
 	ptxdesc->txdw7 |= cpu_to_le32(checksum & 0x0000ffff);
 }

@@ -1772,11 +1772,10 @@ static void rtl8723b_fill_default_txdesc(
 		ptxdesc->mbssid = pattrib->mbssid & 0xF;
 
 		ptxdesc->rty_lmt_en = 1; /*  retry limit enable */
-		if (pattrib->retry_ctrl) {
+		if (pattrib->retry_ctrl)
 			ptxdesc->data_rt_lmt = 6;
-		} else {
+		else
 			ptxdesc->data_rt_lmt = 12;
-		}
 
 		ptxdesc->datarate = MRateToHwRate(pmlmeext->tx_rate);
 

@@ -1867,9 +1866,9 @@ void rtl8723b_fill_fake_txdesc(
 		SET_TX_DESC_HWSEQ_SEL_8723B(pDesc, 0);
 	}
 
-	if (IsBTQosNull) {
+	if (IsBTQosNull)
 		SET_TX_DESC_BT_INT_8723B(pDesc, 1);
-	}
+
 
 	SET_TX_DESC_USE_RATE_8723B(pDesc, 1); /*  use data rate which is set by Sw */
 	SET_TX_DESC_OWN_8723B((u8 *)pDesc, 1);

@@ -2184,9 +2183,9 @@ void CCX_FwC2HTxRpt_8723b(struct adapter *padapter, u8 *pdata, u8 len)
 #define	GET_8723B_C2H_TX_RPT_LIFE_TIME_OVER(_Header)	LE_BITS_TO_1BYTE((_Header + 0), 6, 1)
 #define	GET_8723B_C2H_TX_RPT_RETRY_OVER(_Header)	LE_BITS_TO_1BYTE((_Header + 0), 7, 1)
 
-	if (GET_8723B_C2H_TX_RPT_RETRY_OVER(pdata) | GET_8723B_C2H_TX_RPT_LIFE_TIME_OVER(pdata)) {
+	if (GET_8723B_C2H_TX_RPT_RETRY_OVER(pdata) | GET_8723B_C2H_TX_RPT_LIFE_TIME_OVER(pdata))
 		rtw_ack_tx_done(&padapter->xmitpriv, RTW_SCTX_DONE_CCX_PKT_FAIL);
-	}
+
 /*
 	else if (seq_no != padapter->xmitpriv.seq_no) {
 		rtw_ack_tx_done(&padapter->xmitpriv, RTW_SCTX_DONE_CCX_PKT_FAIL);

@@ -2555,9 +2554,9 @@ void SetHwReg8723B(struct adapter *padapter, u8 variable, u8 *val)
 
 			/*  Forece leave RF low power mode for 1T1R to prevent conficting setting in Fw power */
 			/*  saving sequence. 2010.06.07. Added by tynli. Suggested by SD3 yschang. */
-			if (psmode != PS_MODE_ACTIVE) {
+			if (psmode != PS_MODE_ACTIVE)
 				ODM_RF_Saving(&pHalData->odmpriv, true);
-			}
+
 
 			/* if (psmode != PS_MODE_ACTIVE)	{ */
 			/* 	rtl8723b_set_lowpwr_lps_cmd(padapter, true); */

@@ -2871,11 +2870,11 @@ u8 GetHalDefVar8723B(struct adapter *padapter, enum hal_def_variable variable, v
 		break;
 
 	case HAL_DEF_TX_PAGE_BOUNDARY:
-		if (!padapter->registrypriv.wifi_spec) {
+		if (!padapter->registrypriv.wifi_spec)
 			*(u8 *)pval = TX_PAGE_BOUNDARY_8723B;
-		} else {
+		 else
 			*(u8 *)pval = WMM_NORMAL_TX_PAGE_BOUNDARY_8723B;
-		}
+
 		break;
 
 	case HAL_DEF_MACID_SLEEP: