Skip to contentSkip to conversation

ASoC: fix typos in comments

PATCH New Hemanth Selam 2 participants 5 messages Sep 4

Subsystems (5)
lore
Share & tools
lore
#0 lore raw

cover ASoC: fix typos in comments

This corrects 3 misspellings in comments. Each is a separate patch so that any one of them can be dropped without touching the rest.

Nothing outside comments changes. Every touched C file was checked by dropping its comments, replacing each string literal with a placeholder and collapsing whitespace; what remained was identical before and after, so the compiled code cannot differ.

The mistakes were found with scripts/checkpatch.pl against the list in scripts/spelling.txt. The scanning, the edits and the changelogs were produced with Cursor running the claude-opus-5 model, from a request to find and fix spelling mistakes across the tree, and every correction was then re-checked by the comparison described above. Words that name an identifier were left alone deliberately, even when they read as typos, because correcting the prose would make the comment disagree with the code it describes.

Tested by building x86_64 defconfig at v7.3-rc1-269-gbc35965f6940, which is clean. Nothing else was built, so any patch touching code that x86_64 defconfig does not compile has been read but not compiled.

Hemanth Selam (3):
ASoC: codecs: fix typos in comments
firmware: cirrus: fix typo "upto" in comment
mfd: fix typo "convertor" in comment

 drivers/firmware/cirrus/cs_dsp.c | 2 +-
 drivers/mfd/wm831x-auxadc.c      | 2 +-
 sound/soc/codecs/wm8962.c        | 4 ++--
 sound/soc/codecs/wm8996.c        | 2 +-
 sound/soc/codecs/wm_hubs.c       | 2 +-
 5 files changed, 6 insertions(+), 6 deletions(-)
Signature · 1 line
2.48.1
#1 lore raw

PATCH 1/3 ASoC: codecs: fix typos in comments

Fix typos in comments, reported by scripts/checkpatch.pl using the misspelling list in scripts/spelling.txt. Only touches comments, no code changes.

Assisted-by Cursor:claude-opus-5
---
 sound/soc/codecs/wm8962.c  | 4 ++--
 sound/soc/codecs/wm8996.c  | 2 +-
 sound/soc/codecs/wm_hubs.c | 2 +-
 3 files changed, 4 insertions(+), 4 deletions(-)
sound/soc/codecs/wm8962.c +2 -2
index 8a9598161b35..af4716051220 100644
@@ -3430,7 +3430,7 @@ static int wm8962_gpio_request(struct gpio_chip *chip, unsigned offset)
 
 	/* The WM8962 GPIOs aren't linearly numbered.  For simplicity
 	 * we export linear numbers and error out if the unsupported
-	 * ones are requsted.
+	 * ones are requested.
 	 */
 	switch (offset + 1) {
 	case 2:
@@ -3813,7 +3813,7 @@ static int wm8962_i2c_probe(struct i2c_client *i2c)
 	regmap_update_bits(wm8962->regmap, WM8962_EQ1,
 			   WM8962_EQ_SHARED_COEFF, 0);
 
-	/* Don't debouce interrupts so we don't need SYSCLK */
+	/* Don't debounce interrupts so we don't need SYSCLK */
 	regmap_update_bits(wm8962->regmap, WM8962_IRQ_DEBOUNCE,
 			   WM8962_FLL_LOCK_DB | WM8962_PLL3_LOCK_DB |
 			   WM8962_PLL2_LOCK_DB | WM8962_TEMP_SHUT_DB,
sound/soc/codecs/wm8996.c +1 -1
index dface555f928..e7a20ce39940 100644
@@ -2106,7 +2106,7 @@ static int wm8996_set_fll(struct snd_soc_component *component, int fll_id, int s
 	if (i2c->irq)
 		timeout *= 10;
 	else
-		/* ensure timeout of atleast 1 jiffies */
+		/* ensure timeout of at least 1 jiffies */
 		timeout = (timeout/2) ? : 1;
 
 	for (retry = 0; retry < 10; retry++) {
sound/soc/codecs/wm_hubs.c +1 -1
index f80dfc488e3c..019940589e51 100644
@@ -338,7 +338,7 @@ static int wm8993_put_dc_servo(struct snd_kcontrol *kcontrol,
 	ret = snd_soc_put_volsw(kcontrol, ucontrol);
 
 	/* If we're applying an offset correction then updating the
-	 * callibration would be likely to introduce further offsets. */
+	 * calibration would be likely to introduce further offsets. */
 	if (hubs->dcs_codes_l || hubs->dcs_codes_r || hubs->no_series_update)
 		return ret;
 
Signature · 1 line
2.48.1
#2 lore raw

PATCH 2/3 firmware: cirrus: fix typo "upto" in comment

In reply to Hemanth Selam

Correct "upto" to "up to", reported by scripts/checkpatch.pl using the misspelling list in scripts/spelling.txt. Only touches comments, no code changes.

Assisted-by Cursor:claude-opus-5
---
 drivers/firmware/cirrus/cs_dsp.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)
drivers/firmware/cirrus/cs_dsp.c +1 -1
index bb93b24c659d..04015280ac5d 100644
@@ -3505,7 +3505,7 @@ EXPORT_SYMBOL_NS_GPL(cs_dsp_chunk_write, "FW_CS_DSP");
  *
  * As cs_dsp_chunk_write only writes data when a whole DSP word is ready to
  * be written out it is possible that some data will remain in the cache, this
- * function will pad that data with zeros upto a whole DSP word and write out.
+ * function will pad that data with zeros up to a whole DSP word and write out.
  *
  * Return: Zero for success, a negative number on error.
  */
Signature · 1 line
2.48.1
#3 lore raw

PATCH 3/3 mfd: fix typo "convertor" in comment

In reply to Hemanth Selam

Correct "convertor" to "converter", reported by scripts/checkpatch.pl using the misspelling list in scripts/spelling.txt. Only touches comments, no code changes.

Assisted-by Cursor:claude-opus-5
---
 drivers/mfd/wm831x-auxadc.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)
drivers/mfd/wm831x-auxadc.c +1 -1
index 744e1d161c5a..6280d4f38981 100644
@@ -132,7 +132,7 @@ static irqreturn_t wm831x_auxadc_irq(int irq, void *irq_data)
 			1 << input, 0);
 	wm831x->auxadc_active &= ~(1 << input);
 
-	/* Turn off the entire convertor if idle */
+	/* Turn off the entire converter if idle */
 	if (!wm831x->auxadc_active)
 		wm831x_reg_write(wm831x, WM831X_AUXADC_CONTROL, 0);
 
Signature · 1 line
2.48.1
#4 lore raw

Re: [PATCH 3/3] mfd: fix typo "convertor" in comment

Thank you for your contribution! Sashiko AI review found 1 potential issue(s) to consider: - [Low] The commit message prefix and capitalization violate the MFD subsystem guidelines. --

Thank you for your contribution! Sashiko AI review found 1 potential issue(s) to consider:
- [Low] The commit message prefix and capitalization violate the MFD subsystem guidelines. --

commit 9822de653028134dd1239ce2fd2798565ae60014
Author: Hemanth Selam <[email protected]>

mfd: fix typo "convertor" in comment

This commit corrects a typo ("convertor" to "converter") in a code comment within the wm831x-auxadc driver, as reported by checkpatch.

Quoted 1 line

mfd: fix typo "convertor" in comment

[Severity: Low]
Does this commit message subject follow the MFD subsystem naming conventions?

According to the MFD guidelines, the prefix format should include the driver name and capitalize the description, such as:
mfd: <Driver>: <Capitalized description>

For this patch, it might be better formatted as:
mfd: wm831x-auxadc: Fix typo "convertor" in comment

Signature · 1 line
Sashiko AI review · https://sashiko.dev/#/patchset/[email protected]?part=3