drm/bridge: analogix_dp: use devm_phy_optional_get() for the DP PHY
Subsystems (4)
PATCH v2 1/1 drm/bridge: analogix_dp: use devm_phy_optional_get() for the DP PHY
The DP PHY is optional: the Rockchip RK3399 eDP controller (used as the internal eDP port) has no separate PHY device and relies on its built-in PHY, which is programmed directly through the GRF registers, so its DT node carries no "phys"/"phy-names" property.
Requesting the PHY with devm_phy_get() therefore returns -ENODEV (or -ENOSYS when CONFIG_GENERIC_PHY is disabled) and the driver logs a misleading "no DP phy configured" error at probe time before falling back to a NULL phy.
Use devm_phy_optional_get() instead, which returns NULL when the PHY is absent and otherwise behaves identically, and drop the manual -ENODEV/ -ENOSYS handling. This also removes the spurious error message.
--- .../drm/bridge/analogix/analogix_dp_core.c | 22 ++++++------------- 1 file changed, 7 insertions(+), 15 deletions(-)
drivers/gpu/drm/bridge/analogix/analogix_dp_core.c +7 -15
@@ -1427,21 +1427,13 @@ analogix_dp_probe(struct device *dev, struct analogix_dp_plat_data *plat_data)if (ret)return ERR_PTR (ret); - dp->phy =devm_phy_get (dp->dev,"dp" ); -if (IS_ERR (dp->phy)) { -dev_err (dp->dev,"no DP phy configured\n" ); - ret =PTR_ERR (dp->phy); -if (ret) { -/* -* phy itself is not enabled, so we can move forward -* assigning NULL to phy pointer. -*/ -if (ret == -ENOSYS || ret == -ENODEV ) - dp->phy =NULL ; -else -return ERR_PTR (ret); - } - } +/* +* RK3288/RK3399 use Analogix DP controller built-in PHY, +* no extra PHY configuration is required. +*/ + dp->phy =devm_phy_optional_get (dp->dev,"dp" ); +if (IS_ERR (dp->phy)) +return ERR_CAST (dp->phy); dp->clock =devm_clk_get (&pdev->dev,"dp" );if (IS_ERR (dp->clock)) {
Signature · 1 line
2.55.0