Add basic reset driver for assert/deassert operations
Subsystems (4)
v2 cover Add basic reset driver for assert/deassert operations
This patch series originates from:
https://lists.denx.de/pipermail/u-boot/2022-December/502865.html
Implement a basic driver to enable assert/deassert operations.
v1 -> v2:
- rebase on u-boot next
Cristian Birsan (1):
ARM: at91: add sama7 SFR definitions
Sergiu Moga (1):
reset: at91: Add reset driver for basic assert/deassert operations
arch/arm/mach-at91/include/mach/sama7-sfr.h | 59 ++++++++ drivers/reset/Kconfig | 8 ++ drivers/reset/Makefile | 1 + drivers/reset/reset-at91.c | 141 ++++++++++++++++++++ drivers/sysreset/sysreset_at91.c | 9 +- 5 files changed, 210 insertions(+), 8 deletions(-) create mode 100644 arch/arm/mach-at91/include/mach/sama7-sfr.h create mode 100644 drivers/reset/reset-at91.c
Signature · 1 line
2.34.1
PATCH v2 1/2 ARM: at91: add sama7 SFR definitions
From: Cristian Birsan <[email protected]>
Special Function Registers(SFR) definitions for SAMA7 product family.
---
v1 -> v2:
- nothing
arch/arm/mach-at91/include/mach/sama7-sfr.h | 59 +++++++++++++++++++++ 1 file changed, 59 insertions(+) create mode 100644 arch/arm/mach-at91/include/mach/sama7-sfr.h
arch/arm/mach-at91/include/mach/sama7-sfr.h new file +59 -0
@@ -0,0 +1,59 @@ +/* SPDX-License-Identifier: GPL-2.0-only */ +/* +* Microchip SFR (Special Function Registers) registers for SAMA7 family. +* +* Copyright (C) 2022 Microchip Technology Inc. and its subsidiaries +* +* Author: Cristian Birsan <[email protected]> +*/ + +#ifndef _LINUX_MFD_SYSCON_AT91_SAMA7_SFR_H +#define _LINUX_MFD_SYSCON_AT91_SAMA7_SFR_H + +#define SAMA7_SFR_OHCIICR 0x00/* OHCI INT Configuration Register */ +#define SAMA7_SFR_OHCIISR 0x04/* OHCI INT Status Register */ +/* 0x08 ~ 0xe3: Reserved */ +#define SAMA7_SFR_WPMR 0xe4/* Write Protection Mode Register */ +#define SAMA7_SFR_WPSR 0xe4/* Write Protection Status Register */ +/* 0xec ~ 0x200b: Reserved */ +#define SAMA7_SFR_DEBUG 0x200c/* Debug Register */ + +/* 0x2010 ~ 0x2027: Reserved */ +#define SAMA7_SFR_EHCIOHCI 0x2020/* EHCI OHCI Clock Configuration Reg */ + +#define SAMA7_SFR_HSS_AXI_QOS 0x2028/* HSS AXI QOS Register */ +#define SAMA7_SFR_UDDRC 0x202c/* UDDRC Register */ +#define SAMA7_SFR_CAN_SRAM_SEL 0x2030/* CAN SRAM Select. Register */ +/* 0x2034 ~ 0x203f: Reserved */ + +#define SAMA7_SFR_UTMI0 0x2040 +#define SAMA7_SFR_UTMI0R (x) (SAMA7_SFR_UTMI0 + 4 * (x)) + +#define SAMA7_SFR_UTMI0R0 0x2040/* UTMI0 Configuration Register */ +#define SAMA7_SFR_UTMI0R1 0x2044/* UTMI1 Configuration Register */ +#define SAMA7_SFR_UTMI0R2 0x2048/* UTMI2 Configuration Register */ + +/* Field definitions */ +#define SAMA7_SFR_OHCIICR_ARIE BIT(0) +#define SAMA7_SFR_OHCIICR_APPSTART BIT(1) +#define SAMA7_SFR_OHCIICR_USB_SUSP (x) BIT(8 + (x)) +#define SAMA7_SFR_OHCIICR_USB_SUSPEND GENMASK(10, 8) + +#define SAMA7_SFR_OHCIISR_RIS (x) BIT(x) + +#define SAMA7_SFR_WPMR_WPEN BIT(0) +#define SAMA7_SFR_WPMR_KEY 0x53465200/* SFR in ASCII*/ +#define SAMA7_SFR_WPMR_WPKEY_MASK GENMASK(31, 8) + +#define SAMA7_SFR_WPSR_WPSRC_MASK GENMASK(23, 8) +#define SAMA7_SFR_WPSR_WPVS_MASK BIT(0) + +#define SAMA7_SFR_CAN_SRAM_UPPER (x) BIT(x) + +#define SAMA7_SFR_UTMI_RX_VBUS BIT(25)/* VBUS Valid bit */ +#define SAMA7_SFR_UTMI_RX_TX_PREEM_AMP_TUNE_1X BIT(23)/* TXPREEMPAMPTUNE 1x */ +#define SAMA7_SFR_UTMI_COMMONON BIT(3)/* PLL Common ON bit */ + +#define SAMA7_SFR_EHCIOHCI_PHYCLK BIT(1)/* Alternate PHY Clk */ + +#endif /* _LINUX_MFD_SYSCON_AT91_SAMA7_SFR_H */
Signature · 1 line
2.34.1
PATCH v2 2/2 reset: at91: Add reset driver for basic assert/deassert operations
In reply to Sergiu MogaAdd support for at91 reset controller's basic assert/deassert operations. Since this driver conflicts with the SYSRESET driver because they both bind to the same RSTC node, implement a custom bind hook that would manually bind the sysreset driver, if enabled, to the same RSTC DT node. Furthermore, delete the no longer needed compatibles from the SYSRESET driver and rename it to make sure than any possible conflicts are avoided.
---
v1 -> v2:
- rebase on u-boot next
drivers/reset/Kconfig | 8 ++ drivers/reset/Makefile | 1 + drivers/reset/reset-at91.c | 141 +++++++++++++++++++++++++++++++ drivers/sysreset/sysreset_at91.c | 9 +- 4 files changed, 151 insertions(+), 8 deletions(-) create mode 100644 drivers/reset/reset-at91.c
drivers/reset/Kconfig +8 -0
@@ -211,4 +211,12 @@ config RESET_DRA7 help Support for TI DRA7-RESET subsystem. Basic Assert/Deassert is supported. + +config RESET_AT91 + bool "Enable support for Microchip/Atmel Reset Controller driver" + depends on DM_RESET && ARCH_AT91 + help + This enables the Reset Controller driver support for Microchip/Atmel + SoCs. Mainly used to expose assert/deassert methods to other drivers + that require it. endmenu
drivers/reset/Makefile +1 -0
@@ -31,3 +31,4 @@ obj-$(CONFIG_RESET_RASPBERRYPI) += reset-raspberrypi.o obj-$(CONFIG_RESET_SCMI) += reset-scmi.o obj-$(CONFIG_RESET_ZYNQMP) += reset-zynqmp.o obj-$(CONFIG_RESET_DRA7) += reset-dra7.o +obj-$(CONFIG_RESET_AT91) += reset-at91.o
drivers/reset/reset-at91.c new file +141 -0
141 lines not on this page · raw message
drivers/sysreset/sysreset_at91.c +1 -8
@@ -56,16 +56,9 @@ static struct sysreset_ops at91_sysreset = { .request = at91_sysreset_request, }; -static const struct udevice_id a91_sysreset_ids[] = { - { .compatible ="atmel,sama5d3-rstc" }, - { .compatible ="microchip,sam9x60-rstc" }, - { } -}; -U_BOOT_DRIVER (sysreset_at91) = { .id =UCLASS_SYSRESET , - .name ="at91_reset" , + .name ="at91_sysreset" , .ops = &at91_sysreset, .probe = at91_sysreset_probe, - .of_match = a91_sysreset_ids, };
Signature · 1 line
2.34.1
Quoted 14 lines · Sergiu Moga
This patch series originates from:
https://lists.denx.de/pipermail/u-boot/2022-December/502865.htmlImplement a basic driver to enable assert/deassert operations.
v1 -> v2:
- rebase on u-boot nextCristian Birsan (1):
ARM: at91: add sama7 SFR definitionsSergiu Moga (1):
reset: at91: Add reset driver for basic assert/deassert operations
Quoted 9 lines
arch/arm/mach-at91/include/mach/sama7-sfr.h | 59 ++++++++ drivers/reset/Kconfig | 8 ++ drivers/reset/Makefile | 1 + drivers/reset/reset-at91.c | 141 ++++++++++++++++++++ drivers/sysreset/sysreset_at91.c | 9 +- 5 files changed, 210 insertions(+), 8 deletions(-)create mode 100644
arch/arm/mach-at91/include/mach/sama7-sfr.hcreate mode 100644drivers/reset/reset-at91.c
Applied series to u-boot-at91/next, thanks !