ARM: shmobile: defconfig: Replace USB_RCAR_GEN2_PHY by PHY_RCAR_GEN2
Subsystems (3)
Geert Uytterhoeven
maintainerPATCH 1/2 ARM: shmobile: defconfig: Replace USB_RCAR_GEN2_PHY by PHY_RCAR_GEN2
The legacy-only USB_RCAR_GEN2_PHY driver was replaced by the DT-only PHY_RCAR_GEN2 driver.
Refresh the defconfig using "make savedefconfig" while we're at it.
---
Oops, CONFIG_USB_RCAR_GEN2_PHY shouldn't have been in a multiplatform defconfig, as it supports legacy platform data only.
arch/arm/configs/shmobile_defconfig | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)
arch/arm/configs/shmobile_defconfig +2 -2
@@ -121,7 +121,6 @@ CONFIG_WATCHDOG=y CONFIG_DA9063_WATCHDOG=y CONFIG_MFD_AS3711=y CONFIG_MFD_DA9063=y -CONFIG_REGULATOR=y CONFIG_REGULATOR_AS3711=y CONFIG_REGULATOR_DA9210=y CONFIG_REGULATOR_GPIO=y
@@ -160,7 +159,6 @@ CONFIG_USB_OHCI_HCD=y CONFIG_USB_R8A66597_HCD=y CONFIG_USB_RENESAS_USBHS=y CONFIG_USB_RCAR_PHY=y -CONFIG_USB_RCAR_GEN2_PHY=y CONFIG_USB_GADGET=y CONFIG_USB_RENESAS_USBHS_UDC=y CONFIG_USB_ETH=y
@@ -182,6 +180,8 @@ CONFIG_IIO=y CONFIG_AK8975=y CONFIG_PWM=y CONFIG_PWM_RENESAS_TPU=y +CONFIG_GENERIC_PHY=y +CONFIG_PHY_RCAR_GEN2=y # CONFIG_DNOTIFY is not set CONFIG_MSDOS_FS=y CONFIG_VFAT_FS=y
Signature · 1 line
1.9.1
Geert Uytterhoeven
maintainerPATCH 2/2 ARM: multi_v7_defconfig: Replace USB_RCAR_GEN2_PHY by PHY_RCAR_GEN2
The legacy-only USB_RCAR_GEN2_PHY driver was replaced by the DT-only PHY_RCAR_GEN2 driver.
---
Oops, CONFIG_USB_RCAR_GEN2_PHY shouldn't have been in a multiplatform defconfig, as it supports legacy platform data only.
arch/arm/configs/multi_v7_defconfig | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
arch/arm/configs/multi_v7_defconfig +1 -1
@@ -447,7 +447,6 @@ CONFIG_USB_GPIO_VBUS=y CONFIG_USB_ISP1301=y CONFIG_USB_MXS_PHY=y CONFIG_USB_RCAR_PHY=m -CONFIG_USB_RCAR_GEN2_PHY=m CONFIG_USB_GADGET=y CONFIG_USB_RENESAS_USBHS_UDC=m CONFIG_MMC=y
@@ -561,6 +560,7 @@ CONFIG_OMAP_USB2=y CONFIG_TI_PIPE3=y CONFIG_PHY_MIPHY28LP=y CONFIG_PHY_MIPHY365X=y +CONFIG_PHY_RCAR_GEN2=m CONFIG_PHY_STIH41X_USB=y CONFIG_PHY_STIH407_USB=y CONFIG_PHY_SUN4I_USB=y
Signature · 1 line
1.9.1
PATCH 2/2 ARM: multi_v7_defconfig: Replace USB_RCAR_GEN2_PHY by PHY_RCAR_GEN2
Quoted 7 lines · Geert Uytterhoeven
The legacy-only
USB_RCAR_GEN2_PHYdriver was replaced by the DT-onlyPHY_RCAR_GEN2driver.Signed-off-by Geert Uytterhoeven <[email protected]>---
Oops,CONFIG_USB_RCAR_GEN2_PHYshouldn't have been in a multiplatform defconfig, as it supports legacy platform data only.
Olof, Arnd, Kevin,
I'm assuming that you want to take this directly (or not!). However, if you would like me to queue up these kind of changes in my defconfig branch please just let me know.
PATCH 2/2 ARM: multi_v7_defconfig: Replace USB_RCAR_GEN2_PHY by PHY_RCAR_GEN2
[CC Kevin]
Quoted 9 lines · Simon Horman
Quoted 7 lines · Geert Uytterhoeven
The legacy-only
USB_RCAR_GEN2_PHYdriver was replaced by the DT-onlyPHY_RCAR_GEN2driver.Signed-off-by Geert Uytterhoeven <[email protected]>---
Oops,CONFIG_USB_RCAR_GEN2_PHYshouldn't have been in a multiplatform defconfig, as it supports legacy platform data only.
Quoted 7 lines
Acked-by Simon Horman <[email protected]>Olof, Arnd, Kevin,
I'm assuming that you want to take this directly (or not!). However, if you would like me to queue up these kind of changes in my defconfig branch please just let me know.
Hi,
I'm wondering if you could take a moment to either review this patch or indicate that you would like me to queue up changes like this.
PATCH 2/2 ARM: multi_v7_defconfig: Replace USB_RCAR_GEN2_PHY by PHY_RCAR_GEN2
Quoted 14 lines · On Saturday 09 May 2015 11:14:03 Simon Horman wrote:
Quoted 13 lines · Simon Horman
Quoted 7 lines · Geert Uytterhoeven
The legacy-only
USB_RCAR_GEN2_PHYdriver was replaced by the DT-onlyPHY_RCAR_GEN2driver.Signed-off-by Geert Uytterhoeven <[email protected]>---
Oops,CONFIG_USB_RCAR_GEN2_PHYshouldn't have been in a multiplatform defconfig, as it supports legacy platform data only.Acked-by Simon Horman <[email protected]>Olof, Arnd, Kevin,
Quoted 8 lines
Quoted 3 lines
I'm assuming that you want to take this directly (or not!). However, if you would like me to queue up these kind of changes in my defconfig branch please just let me know.
Hi,
I'm wondering if you could take a moment to either review this patch or indicate that you would like me to queue up changes like this.
The patch looks ok to me, and I've queued it up in the next/defconfig branch for 4.2 now.
In general, I think it's easier if you take all patches at first and then forward them to us, that way we can rely on you to have an overview of what is missing.
If you only have one patch for a particular branch, sending a patch (instead of a pull request) to arm at kernel.org works as well, but it's less ambiguous if you relay that patch with your signed-off-by line added than to have us figure out whether you want the patch to be applied directly or not.
Arnd
PATCH 2/2 ARM: multi_v7_defconfig: Replace USB_RCAR_GEN2_PHY by PHY_RCAR_GEN2
Hi Arnd,
Quoted 19 lines · Arnd Bergmann
Quoted 18 lines · On Saturday 09 May 2015 11:14:03 Simon Horman wrote:
Quoted 16 lines · Simon Horman
Quoted 7 lines · Geert Uytterhoeven
The legacy-only
USB_RCAR_GEN2_PHYdriver was replaced by the DT-onlyPHY_RCAR_GEN2driver.Signed-off-by Geert Uytterhoeven <[email protected]>---
Oops,CONFIG_USB_RCAR_GEN2_PHYshouldn't have been in a multiplatform defconfig, as it supports legacy platform data only.Acked-by Simon Horman <[email protected]>Olof, Arnd, Kevin,
I'm assuming that you want to take this directly (or not!). However, if you would like me to queue up these kind of changes in my defconfig branch please just let me know.
Quoted 7 lines
Quoted 4 lines
Hi,
I'm wondering if you could take a moment to either review this patch or indicate that you would like me to queue up changes like this.
The patch looks ok to me, and I've queued it up in the next/defconfig branch for 4.2 now.
Thanks!
Quoted 9 lines
In general, I think it's easier if you take all patches at first and then forward them to us, that way we can rely on you to have an overview of what is missing.
If you only have one patch for a particular branch, sending a patch (instead of a pull request) to arm at kernel.org works as well, but it's less ambiguous if you relay that patch with your signed-off-by line added than to have us figure out whether you want the patch to be applied directly or not.
I think Simon's question was more about asking what's the proper process for updating multi_v7_defconfig.
Should this go through you / arm at kernel.org directly?
Should it go through arm subarchitecture maintainers, causing merge conflicts?
BTW, arm at kernel.org isn't documented in MAINTAINERS.
Gr{oetje,eeting}s,
Geert
--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- geert at linux-m68k.org
In personal conversations with technical people, I call myself a hacker. But when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds
PATCH 2/2 ARM: multi_v7_defconfig: Replace USB_RCAR_GEN2_PHY by PHY_RCAR_GEN2
Quoted 6 lines · On Tuesday 12 May 2015 18:30:59 Geert Uytterhoeven wrote:
I think Simon's question was more about asking what's the proper process for updating
multi_v7_defconfig.Should this go through you / arm at kernel.org directly?
Should it go through arm subarchitecture maintainers, causing merge conflicts?
I think it should go through subarch maintainers, and we'll handle the conflicts as they arise when merging into the next/defconfig branch. This does mean that it's important to send the defconfig changes separately from other changes if possible, but it's fine to have a branch that touches both platform-specific and generic defconfig files.
Quoted 1 line
BTW, arm at kernel.org isn't documented in
MAINTAINERS.
Right, that is intentional. We don't want to get Cc'd on 4000 patches per month that get sent to the mailing list for mach-*. By having a maintainer for each subdirectory and letting them decide what to forward to us, we're able to do our job better.
Arnd
PATCH 2/2 ARM: multi_v7_defconfig: Replace USB_RCAR_GEN2_PHY by PHY_RCAR_GEN2
Hi Arnd, Hi Geert,
Quoted 5 lines · Arnd Bergmann
Quoted 4 lines · On Tuesday 12 May 2015 18:30:59 Geert Uytterhoeven wrote:
I think Simon's question was more about asking what's the proper process for updating
multi_v7_defconfig.
Quoted 8 lines
Quoted 2 lines
Should this go through you / arm at kernel.org directly?
Should it go through arm subarchitecture maintainers, causing merge conflicts?I think it should go through subarch maintainers, and we'll handle the conflicts as they arise when merging into the next/defconfig branch. This does mean that it's important to send the defconfig changes separately from other changes if possible, but it's fine to have a branch that touches both platform-specific and generic defconfig files.
Thanks, that is now completely clear to me.
FWIW, I am currently seeing one or two generic config changes per release cycle. Which implies to me that conflicts should be minimal.
Quoted 9 lines
Quoted 1 line
BTW, arm at kernel.org isn't documented in
MAINTAINERS.Right, that is intentional. We don't want to get Cc'd on 4000 patches per month that get sent to the mailing list for mach-*. By having a maintainer for each subdirectory and letting them decide what to forward to us, we're able to do our job better.
Arnd
PATCH 1/2 ARM: shmobile: defconfig: Replace USB_RCAR_GEN2_PHY by PHY_RCAR_GEN2
In reply to Geert UytterhoevenQuoted 9 lines · Geert Uytterhoeven
The legacy-only
USB_RCAR_GEN2_PHYdriver was replaced by the DT-onlyPHY_RCAR_GEN2driver.Refresh the defconfig using "make savedefconfig" while we're at it.
Signed-off-by Geert Uytterhoeven <[email protected]>---
Oops,CONFIG_USB_RCAR_GEN2_PHYshouldn't have been in a multiplatform defconfig, as it supports legacy platform data only.
Thanks for cleaning this up.
I have queued this up for v4.2.
Quoted 41 lines
arch/arm/configs/shmobile_defconfig | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-)arch/arm/configs/shmobile_defconfig +2
-2@@ -121,7 +121,6 @@ CONFIG_WATCHDOG=y CONFIG_DA9063_WATCHDOG=y CONFIG_MFD_AS3711=y CONFIG_MFD_DA9063=y -CONFIG_REGULATOR=y CONFIG_REGULATOR_AS3711=y CONFIG_REGULATOR_DA9210=y CONFIG_REGULATOR_GPIO=y@@ -160,7 +159,6 @@ CONFIG_USB_OHCI_HCD=y CONFIG_USB_R8A66597_HCD=y CONFIG_USB_RENESAS_USBHS=y CONFIG_USB_RCAR_PHY=y -CONFIG_USB_RCAR_GEN2_PHY=y CONFIG_USB_GADGET=y CONFIG_USB_RENESAS_USBHS_UDC=y CONFIG_USB_ETH=y@@ -182,6 +180,8 @@ CONFIG_IIO=y CONFIG_AK8975=y CONFIG_PWM=y CONFIG_PWM_RENESAS_TPU=y +CONFIG_GENERIC_PHY=y +CONFIG_PHY_RCAR_GEN2=y # CONFIG_DNOTIFY is not set CONFIG_MSDOS_FS=y CONFIG_VFAT_FS=ySignature · 6 lines
1.9.1 -- To unsubscribe from this list: send the line "unsubscribe linux-sh" in the body of a message to majordomo at vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html