spi: dt-bindings: nuvoton,npcm-pspi: Convert to DT schema
Subsystems (3)
Tomer Maimon
maintainerPATCH v2 1/1 spi: dt-bindings: nuvoton,npcm-pspi: Convert to DT schema
Convert the Nuvoton NPCM PSPI binding to DT schema format.
Also update the binding to fix shortcoming:
* Drop clock-frequency property: it is never read in the NPCM PSPI driver and has no effect.
---
Addressed comments from:
- Krzysztof Kozlowski: https://patchwork.ozlabs.org/project/openbmc/patch/[email protected]/
Changes since version 1:
- Fix commit subject and message.
- Drop unnecessary description.
- Use GPIO defines.
- Add clock-names property.
.../bindings/spi/nuvoton,npcm-pspi.txt | 36 ---------- .../bindings/spi/nuvoton,npcm-pspi.yaml | 72 +++++++++++++++++++ 2 files changed, 72 insertions(+), 36 deletions(-) delete mode 100644 Documentation/devicetree/bindings/spi/nuvoton,npcm-pspi.txt create mode 100644 Documentation/devicetree/bindings/spi/nuvoton,npcm-pspi.yaml
Documentation/devicetree/bindings/spi/nuvoton,npcm-pspi.txt deleted +0 -36
@@ -1,36 +0,0 @@ -Nuvoton NPCM Peripheral Serial Peripheral Interface(PSPI) controller driver - -Nuvoton NPCM7xx SOC support two PSPI channels. - -Required properties: - - compatible : "nuvoton,npcm750-pspi" for Poleg NPCM7XX. - "nuvoton,npcm845-pspi" for Arbel NPCM8XX. - - #address-cells : should be 1. see spi-bus.txt - - #size-cells : should be 0. see spi-bus.txt - - specifies physical base address and size of the register. - - interrupts : contain PSPI interrupt. - - clocks : phandle of PSPI reference clock. - - clock-names: Should be "clk_apb5". - - pinctrl-names : a pinctrl state named "default" must be defined. - - pinctrl-0 : phandle referencing pin configuration of the device. - - resets : phandle to the reset control for this device. - - cs-gpios: Specifies the gpio pins to be used for chipselects. - See: Documentation/devicetree/bindings/spi/spi-bus.txt - -Optional properties: -- clock-frequency : Input clock frequency to the PSPI block in Hz. - Default is 25000000 Hz. - -spi0: spi@f0200000 { - compatible = "nuvoton,npcm750-pspi"; - reg = <0xf0200000 0x1000>; - pinctrl-names = "default"; - pinctrl-0 = <&pspi1_pins>; - #address-cells = <1>; - #size-cells = <0>; - interrupts = <GIC_SPI 31 IRQ_TYPE_LEVEL_HIGH>; - clocks = <&clk NPCM7XX_CLK_APB5>; - clock-names = "clk_apb5"; - resets = <&rstc NPCM7XX_RESET_IPSRST2 NPCM7XX_RESET_PSPI1> - cs-gpios = <&gpio6 11 GPIO_ACTIVE_LOW>; -};
Documentation/devicetree/bindings/spi/nuvoton,npcm-pspi.yaml new file +72 -0
72 lines not on this page · raw message
Signature · 1 line
2.34.1
Quoted 8 lines · Tomer Maimon
Convert the Nuvoton NPCM PSPI binding to DT schema format.
Also update the binding to fix shortcoming:
* Drop clock-frequency property: it is never read in the NPCM PSPI driver and has no effect.Signed-off-by Tomer Maimon <[email protected]>---
Best regards,
Krzysztof
Mark Brown
maintainerQuoted 8 lines · Tomer Maimon
Convert the Nuvoton NPCM PSPI binding to DT schema format.
Also update the binding to fix shortcoming:
* Drop clock-frequency property: it is never read in the NPCM PSPI driver and has no effect.[...]
Applied to
https://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi.git for-next
Thanks!
[1/1] spi: dt-bindings: nuvoton,npcm-pspi: Convert to DT schema
commit: 1d562ba0aa7df81335bf96c02be77efe8d5bab87
All being well this means that it will be integrated into the linux-next tree (usually sometime in the next 24 hours) and sent to Linus during the next merge window (or sooner if it is a bug fix), however if problems are discovered then the patch may be dropped or reverted.
You may get further e-mails resulting from automated or manual testing and review of the tree, please engage with people reporting problems and send followup patches addressing any issues that are reported if needed.
If any updates are required or you are submitting further changes they should be sent as incremental updates against current git, existing patches will not be replaced.
Please add any relevant lists and maintainers to the CCs when replying to this mail.
Thanks,
Mark