moving u-boot to upper address
I want u-boot to live in the upper boot area 0xfff00000.
So I have
undef'd _BOOT_LOW
changed TEXT_BASE to be 0xfff00000
changed CFG_MONITOR_BASE to be TEXT_BASE
I realize that the HRCW will now be placed at 0xfff00000 and the actual code will begin at 0xfff00100 - this is okay, I will handle the HRCW seperatly.
I just want to know if there is anything wrong with what I have done or if there is anything else I need to do? There are, as you know, many dependancies and I am afraid I might have missed one.
I am dealing with custom hardware and I don't have a hardware debugger - lots of flash and crash so I am not exactly sure where my problem is.
Thanks!
Mitch
--------------------------------------------------------------------
mail2web - Check your email from the web at
http://mail2web.com/ .
Quoted 1 line · In message <[email protected]> you wrote:
I want u-boot to live in the upper boot area
0xfff00000.
Which processor and board are you talking about?
Quoted 1 line
I just want to know if there is anything wrong with what I have done or if
How should we know? You don't bother the mantion anything about your hardware. this could be an ARM system, and all you did is completely bogus.
Quoted 2 lines
I am dealing with custom hardware and I don't have a hardware debugger - lots of flash and crash so I am not exactly sure where my problem is.
Then proceed one step by eanother. Step 1 is to buy a BDI2000.
Best regards,
Wolfgang Denk
Signature · 4 lines
Software Engineering: Embedded and Realtime Systems, Embedded Linux Phone: (+49)-8142-4596-87 Fax: (+49)-8142-4596-88 Email: wd at denx.de Quote from a recent meeting: "We are going to continue having these meetings everyday until I find out why no work is getting done."