Installing u-boot on sbc8260 via ethernet using minicom
i've tryed to install u-boot using minicom, but i'm not able to=20 configure in shell boot params,=20
using this...
boot device : motfcc
unit number : 0
processor number : 0
host name : motfcc0
inet on ethernet (e) : 192.168.0.4
inet on backplane (b): 192.168.0.4
host inet (h) : 192.168.0.3
gateway inet (g) : 192.168.0.3
flags (f) : 0x80
target name (tn) : sbc8260
when i reboot target it appears in minicom the message below:
AT S7=3D45 S0=3D0 L1 V1 X4 &c1 E1 Q0 0x1f058b0 (tBoot): miiPhyInit check cable connection Attached TCP/IP interface to motfcc0.
Warning: no netmask specified.
Attaching network interface lo0... done. Loading... Erroneous header read
Error loading file: errno =3D 0x610001.
Can't load boot file!!
=C3=BC
my questions are?
what file must i put into target?(u-boot.bin?)
in which way can i upload it?(using tftp with 192.168.0.4 and using=20 put command, it gives timeout for transmission, but ping to=20 192.168.0.3=20
works normally until in minicom appears error message)
Please help me to configure and install u-boot
thanks very much!!!
Naviga e telefona senza limiti con Tiscali =20
Scopri le promozioni Tiscali adsl: navighi e telefoni senza canone Telecom