2.5.5[01]]: Xircom Cardbus broken (PCI resource collisions)
Quoted 9 lines · On Fri, 13 Dec 2002 [email protected] wrote:
Quoted 7 lines · Dave Jones
Quoted 3 lines
It's my understanding that
pci_enable_device()*must* be called before we fiddle withdev->resource,dev->irqand the like.OK.. it looks like the problem only hits if it's a PCMCIA card *with an onboard ROM*.
Hmm i just saw this thread, which card is the non working one?;
It's a RBEM56G-100.
Sorry it took me a while to reply - Valdis' patch does fix the problem for
me, too. Awaiting for a final form of the fix in the upcoming series :)
Thanks,
--alessandro
Quoted 6 lines · ALESSANDRO.SUARDI
Quoted 6 lines · On Fri, 13 Dec 2002 [email protected] wrote:
Quoted 5 lines · Dave Jones
Quoted 3 lines
It's my understanding that
pci_enable_device()*must* be called before we fiddle withdev->resource,dev->irqand the like.
Quoted 8 lines
Quoted 3 lines
Quoted 2 lines
OK.. it looks like the problem only hits if it's a PCMCIA card *with an onboard ROM*.
Hmm i just saw this thread, which card is the non working one?;
It's a RBEM56G-100.
Sorry it took me a while to reply - Valdis' patch does fix the problem for
me, too. Awaiting for a final form of the fix in the upcoming series :)
Same here. I was getting bit on a Xircom card:
03:00.0 Ethernet controller: Xircom Cardbus Ethernet 10/100 (rev 03) 03:00.1 Serial controller: Xircom Cardbus Ethernet + 56k Modem (rev 03)
Dave has a point about not poking IRQ's before it's initialized, so I think I'll let him and Alan discuss the *right* way to fix it. (Though if there's need to test a patch more elegant/correct than mine, I'm more than happy to do so...)
Signature · 3 lines
Valdis Kletnieks Computer Systems Senior Engineer Virginia Tech