Skip to contentSkip to conversation

ethernet driver...

parisc-linux Alex deVries 2 participants 2 messages Oct 4, 1999

lore
Share & tools
lore
#0 lore raw

I've cleaned up dino.c sufficiently that tulips are detected, although somewhat broken still:

The PCI BIOS has not enabled this device! Updating PCI command
1011->1015.
tulip.c:v0.89H 5/23/98
[email protected]
eth0: Digital DS21140 Tulip at 0x82223800, EEPROM not present, 00 4c 69 6e 75 7.
eth0: Old style EEPROM -- no media selection
information.
PCI latency timer (CFLT) is unreasonably low at 0. Setting to 64
clocks.
The PCI BIOS has not enabled this device! Updating PCI command
1011->1015.
eth1: Digital DS21142/3 Tulip at 0xff00, EEPROM not present, 00 4c 69 6e 75 7a,.
eth1: Old style EEPROM -- no media selection
information.
PCI latency timer (CFLT) is unreasonably low at 0. Setting to 64
clocks.

Two things to note here:
- I'm not running pcibios_fixup (or whatever) yet, haven't figured out what this is supposed to do
- in tulip.c, there's really only one addition having to do with EEPROM detection, and I think I've messed that up. The MACs shown are incorrect.

We're getting to the point where most PCI devices will start to be detected.

- Alex

Signature · 3 lines
Alex deVries
Vice President of Engineering
The Puffin Group
#1 lore raw
Quoted 5 lines

I've cleaned up dino.c sufficiently that tulips are detected, although somewhat broken still:

The PCI BIOS has not enabled this device! Updating PCI command
1011->1015.

That is reaosnably expected. The various control bits arent enabled by the PA firmware

Quoted 2 lines

PCI latency timer (CFLT) is unreasonably low at 0. Setting to 64
clocks.

And this is also a register where the PCI BIOS would have done the work on a PC. That looks fine.

Quoted 6 lines

- in tulip.c, there's really only one addition having to do with EEPROM detection, and I think I've messed that up. The MACs shown are incorrect.

We're getting to the point where most PCI devices will start to be detected.

Wheee