remoteproc: Add support for xo clock

Add xo clock support required to boot up Qualcomm ADSP processor. The ADSP remoteproc driver keeps xo clock enabled until the driver receives "handover" irq, in order to allow ADSP processor to vote for xo clock with rpm.

Signed-off-by Sarangdhar Joshi <[email protected]>

---

 drivers/remoteproc/qcom_adsp_pil.c | 30 +++++++++++++++++++++++++++++-
 1 file changed, 29 insertions(+), 1 deletion(-)

drivers/remoteproc/qcom_adsp_pil.c +29 -1

index 9141633..5bb25d1 100644
@@ -15,6 +15,7 @@
  * GNU General Public License for more details.
  */
 
+#include <linux/clk.h>
 #include <linux/firmware.h>
 #include <linux/interrupt.h>
 #include <linux/kernel.h>

@@ -48,6 +49,8 @@ struct qcom_adsp {
 	struct qcom_smem_state *state;
 	unsigned stop_bit;
 
+	struct clk *xo;
+
 	struct regulator *cx_supply;
 
 	struct completion start_done;

@@ -102,10 +105,14 @@ static int adsp_start(struct rproc *rproc)
 	struct qcom_adsp *adsp = (struct qcom_adsp *)rproc->priv;
 	int ret;
 
-	ret = regulator_enable(adsp->cx_supply);
+	ret = clk_prepare_enable(adsp->xo);
 	if (ret)
 		return ret;
 
+	ret = regulator_enable(adsp->cx_supply);
+	if (ret)
+		goto disable_clocks;
+
 	ret = qcom_scm_pas_auth_and_reset(ADSP_PAS_ID);
 	if (ret) {
 		dev_err(adsp->dev,

@@ -126,6 +133,8 @@ static int adsp_start(struct rproc *rproc)
 
 disable_regulators:
 	regulator_disable(adsp->cx_supply);
+disable_clocks:
+	clk_disable_unprepare(adsp->xo);
 
 	return ret;
 }

@@ -223,6 +232,21 @@ static irqreturn_t adsp_stop_ack_interrupt(int irq, void *dev)
 	return IRQ_HANDLED;
 }
 
+static int adsp_init_clock(struct qcom_adsp *adsp)
+{
+	int ret;
+
+	adsp->xo = devm_clk_get(adsp->dev, "xo");
+	if (IS_ERR(adsp->xo)) {
+		ret = PTR_ERR(adsp->xo);
+		if (ret != -EPROBE_DEFER)
+			dev_err(adsp->dev, "failed to get xo clock");
+		return ret;
+	}
+
+	return 0;
+}
+
 static int adsp_init_regulator(struct qcom_adsp *adsp)
 {
 	adsp->cx_supply = devm_regulator_get(adsp->dev, "cx");

@@ -320,6 +344,10 @@ static int adsp_probe(struct platform_device *pdev)
 	if (ret)
 		goto free_rproc;
 
+	ret = adsp_init_clock(adsp);
+	if (ret)
+		goto free_rproc;
+
 	ret = adsp_init_regulator(adsp);
 	if (ret)
 		goto free_rproc;

Add xo clock support required to boot up Qualcomm ADSP processor. The ADSP remoteproc driver keeps xo clock enabled until the driver receives "handover" irq, in order to allow ADSP processor to vote for xo clock with rpm.

Signed-off-by Sarangdhar Joshi <[email protected]>

---
 drivers/remoteproc/qcom_adsp_pil.c | 30 +++++++++++++++++++++++++++++-
 1 file changed, 29 insertions(+), 1 deletion(-)

drivers/remoteproc/qcom_adsp_pil.c +29 -1

index 9141633..5bb25d1 100644
@@ -15,6 +15,7 @@
  * GNU General Public License for more details.
  */
 
+#include <linux/clk.h>
 #include <linux/firmware.h>
 #include <linux/interrupt.h>
 #include <linux/kernel.h>

@@ -48,6 +49,8 @@ struct qcom_adsp {
 	struct qcom_smem_state *state;
 	unsigned stop_bit;
 
+	struct clk *xo;
+
 	struct regulator *cx_supply;
 
 	struct completion start_done;

@@ -102,10 +105,14 @@ static int adsp_start(struct rproc *rproc)
 	struct qcom_adsp *adsp = (struct qcom_adsp *)rproc->priv;
 	int ret;
 
-	ret = regulator_enable(adsp->cx_supply);
+	ret = clk_prepare_enable(adsp->xo);
 	if (ret)
 		return ret;
 
+	ret = regulator_enable(adsp->cx_supply);
+	if (ret)
+		goto disable_clocks;
+
 	ret = qcom_scm_pas_auth_and_reset(ADSP_PAS_ID);
 	if (ret) {
 		dev_err(adsp->dev,

@@ -126,6 +133,8 @@ static int adsp_start(struct rproc *rproc)
 
 disable_regulators:
 	regulator_disable(adsp->cx_supply);
+disable_clocks:
+	clk_disable_unprepare(adsp->xo);
 
 	return ret;
 }

@@ -223,6 +232,21 @@ static irqreturn_t adsp_stop_ack_interrupt(int irq, void *dev)
 	return IRQ_HANDLED;
 }
 
+static int adsp_init_clock(struct qcom_adsp *adsp)
+{
+	int ret;
+
+	adsp->xo = devm_clk_get(adsp->dev, "xo");
+	if (IS_ERR(adsp->xo)) {
+		ret = PTR_ERR(adsp->xo);
+		if (ret != -EPROBE_DEFER)
+			dev_err(adsp->dev, "failed to get xo clock");
+		return ret;
+	}
+
+	return 0;
+}
+
 static int adsp_init_regulator(struct qcom_adsp *adsp)
 {
 	adsp->cx_supply = devm_regulator_get(adsp->dev, "cx");

@@ -320,6 +344,10 @@ static int adsp_probe(struct platform_device *pdev)
 	if (ret)
 		goto free_rproc;
 
+	ret = adsp_init_clock(adsp);
+	if (ret)
+		goto free_rproc;
+
 	ret = adsp_init_regulator(adsp);
 	if (ret)
 		goto free_rproc;

Signature · 2 lines

The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project

Quoted 4 lines · Sarangdhar Joshi

Add xo clock support required to boot up Qualcomm ADSP processor. The ADSP remoteproc driver keeps xo clock enabled until the driver receives "handover" irq, in order to allow ADSP processor to vote for xo clock with rpm.

Looks good, thanks.

We have to add the clock to the DT binding and run that by Rob again, before merging the driver and this patch.

Quoted 8 lines · Bjorn Andersson

Quoted 4 lines · Sarangdhar Joshi

Add xo clock support required to boot up Qualcomm ADSP processor. The ADSP remoteproc driver keeps xo clock enabled until the driver receives "handover" irq, in order to allow ADSP processor to vote for xo clock with rpm.

Looks good, thanks.

Quoted 3 lines

We have to add the clock to the DT binding and run that by Rob again, before merging the driver and this patch.

Maybe we should make the xo clock required. We always have a clock for it somewhere, either RPM controlled or as a fixed rate clock so it should work just as well.

Quoted 12 lines · Stephen Boyd

Quoted 11 lines · Bjorn Andersson

Quoted 4 lines · Sarangdhar Joshi

Add xo clock support required to boot up Qualcomm ADSP processor. The ADSP remoteproc driver keeps xo clock enabled until the driver receives "handover" irq, in order to allow ADSP processor to vote for xo clock with rpm.

Looks good, thanks.

We have to add the clock to the DT binding and run that by Rob again, before merging the driver and this patch.

Quoted 4 lines

Maybe we should make the xo clock required. We always have a clock for it somewhere, either RPM controlled or as a fixed rate clock so it should work just as well.

As far as I can see it is required, after Sarangdhar's patch - so this is what I meant we need to add to the DT binding before merging that. And as you say, we can always make it reference "xo_board" for now.

Quoted 4 lines · Sarangdhar Joshi

Add xo clock support required to boot up Qualcomm ADSP processor. The ADSP remoteproc driver keeps xo clock enabled until the driver receives "handover" irq, in order to allow ADSP processor to vote for xo clock with rpm.

Looks good, thanks.

We have to add the clock to the DT binding and run that by Rob again, before merging the driver and this patch.

Regards,
Bjorn

Quoted 90 lines

Signed-off-by Sarangdhar Joshi <[email protected]>

---
 drivers/remoteproc/qcom_adsp_pil.c | 30 +++++++++++++++++++++++++++++-
 1 file changed, 29 insertions(+), 1 deletion(-)

drivers/remoteproc/qcom_adsp_pil.c +29 -2

index 9141633..5bb25d1 100644
@@ -15,6 +15,7 @@
  * GNU General Public License for more details.
  */
 
+#include <linux/clk.h>
 #include <linux/firmware.h>
 #include <linux/interrupt.h>
 #include <linux/kernel.h>

@@ -48,6 +49,8 @@ struct qcom_adsp {
 	struct qcom_smem_state *state;
 	unsigned stop_bit;
 
+	struct clk *xo;
+
 	struct regulator *cx_supply;
 
 	struct completion start_done;

@@ -102,10 +105,14 @@ static int adsp_start(struct rproc *rproc)
 	struct qcom_adsp *adsp = (struct qcom_adsp *)rproc->priv;
 	int ret;
 
-	ret = regulator_enable(adsp->cx_supply);
+	ret = clk_prepare_enable(adsp->xo);
 	if (ret)
 		return ret;
 
+	ret = regulator_enable(adsp->cx_supply);
+	if (ret)
+		goto disable_clocks;
+
 	ret = qcom_scm_pas_auth_and_reset(ADSP_PAS_ID);
 	if (ret) {
 		dev_err(adsp->dev,

@@ -126,6 +133,8 @@ static int adsp_start(struct rproc *rproc)
 
 disable_regulators:
 	regulator_disable(adsp->cx_supply);
+disable_clocks:
+	clk_disable_unprepare(adsp->xo);
 
 	return ret;
 }

@@ -223,6 +232,21 @@ static irqreturn_t adsp_stop_ack_interrupt(int irq, void *dev)
 	return IRQ_HANDLED;
 }
 
+static int adsp_init_clock(struct qcom_adsp *adsp)
+{
+	int ret;
+
+	adsp->xo = devm_clk_get(adsp->dev, "xo");
+	if (IS_ERR(adsp->xo)) {
+		ret = PTR_ERR(adsp->xo);
+		if (ret != -EPROBE_DEFER)
+			dev_err(adsp->dev, "failed to get xo clock");
+		return ret;
+	}
+
+	return 0;
+}
+
 static int adsp_init_regulator(struct qcom_adsp *adsp)
 {
 	adsp->cx_supply = devm_regulator_get(adsp->dev, "cx");

@@ -320,6 +344,10 @@ static int adsp_probe(struct platform_device *pdev)
 	if (ret)
 		goto free_rproc;
 
+	ret = adsp_init_clock(adsp);
+	if (ret)
+		goto free_rproc;
+
 	ret = adsp_init_regulator(adsp);
 	if (ret)
 		goto free_rproc;
--

The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project