Kernel >=2.2.16 on Lombard
Hi,
I'm not able to use either linuxBenh or linuxStable, which I rsynced some hours ago from linuxcare, on my Lombard. I use the .config as supplied (just calling make oldconfig before make dep etc.). My last kernel I built was 2.2.15pre19 from one of the above sources, and it works well.
linuxBenh, which identifies itself as version 2.2.16, will stop early during boot with the message:
pmac nvram is core99: 0
Don't know how to access NVRAM with 0 addresses.
linuxStable, which identifies itself as version 2.2.17pre3 will stop even earlier, after the line
booting...
was printed. If anybody was succesful in using one of the above kernels on the Lombard I'd appreciate, if you could send me your .config.
Thank you
claudio
--
Claudio Nieder, Kanalweg 1, CH-8610 Uster, Tel +41 79 357 6743 mailto:[email protected] http://www.claudio.ch icq:42315212
** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/
Hi,
Quoted 5 lines
linuxBenh, which identifies itself as version 2.2.16, will stop early during boot with the message:
pmac nvram is core99: 0
Don't know how to access NVRAM with 0 addresses.
Benjamin has modified his sources, so that this error will not happen anymore. Thank you very much.
Quoted 4 lines
linuxStable, which identifies itself as version 2.2.17pre3 will stop even earlier, after the line
booting...
linuxStable was upgraded to 2.2.17pre7. I tried to compile the new source, and the resulting kernel works also. My thanks go to whoever fixed that.
claudio
--
Claudio Nieder, Kanalweg 1, CH-8610 Uster, Tel +41 79 357 6743 mailto:[email protected] http://www.claudio.ch icq:42315212
** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/