8260, FCC and local bus
Hello list,
Has anyone done anything with mapping local bus memory so that it can be used for FCC BD's and buffers?
I **thought** I had it right, but my driver eventually causes the machine to hang (EST SBC8260).
I had ioremap'd it, and put va's and pa's where each belonged (va's for the kernel's tracking stuff and pa's for the CPM stuff).
Alas, to no avail.
Has anyone had any success with this, and if so, would you be willing to share?
TIA,
--
Matt Gessner, [email protected]
Senior Software Engineer, R&D
Applied Innovation, Inc.
614-798-2000
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
Quoted 17 lines · Matt Gessner
Hello list,
Has anyone done anything with mapping local bus memory so that it can be used for FCC BD's and buffers?
I **thought** I had it right, but my driver eventually causes the machine to hang (EST SBC8260).
I had ioremap'd it, and put va's and pa's where each belonged (va's for the kernel's tracking stuff and pa's for the CPM stuff).
Alas, to no avail.
Has anyone had any success with this, and if so, would you be willing to share?
Quoted 8 lines
TIA,
--
Matt Gessner, [email protected]
Senior Software Engineer, R&D
Applied Innovation, Inc.
614-798-2000
Sigh.
Check RSTATE and TSTATE (for FCRx) .
Thanks anyway.
--
Matt Gessner, [email protected]
Senior Software Engineer, R&D
Applied Innovation, Inc.
614-798-2000
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
Quoted 2 lines · Matt Gessner
I had ioremap'd it, and put va's and pa's where each belonged (va's for the kernel's tracking stuff and pa's for the CPM stuff).
The va/pa macros are not going to work on Local memory addresses. You have to explicitly compute these addresses.
I have a board with some local memory. I'll test it.
-- Dan
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/