Skip to contentSkip to conversation

Problems with a Magik1 chipset board

DISCUSSION David Pyke 2 participants 2 messages Feb 5, 2001

lore
Share & tools
lore

David Pyke

author
#0 lore raw

I own a Iwill KA266 which uses the ALi M1647 northbridge and M1535D+ south. I'm getting errors on startup and thought I should see if this is an issue with the set or kernel 2.4.1

First, during the ALI15X3 starup I get:

PCI: No IRQ known for interrupt pin A of device 00:04.0. Please try pci=biosirq

according to /proc/pci,00:04.0 is an ALi M5229 IDE (rev 196).

Second, for agpgart I have to use try_agp_unsupported=1 which gets me

agpgart: Trying generic Ali routines for device id: 1647

according to my nvidia driver proc entry, agp is not enabled.

Is there more information I should provide?

Thanks
Dave Pyke

Signature · 6 lines
No disclaimer shall be read or observed.  Any person (either corporate or individual) making any statement shall be held civily and criminally liable as a party to any act I may do while following the intentional, implied or inferred (whether correctly or not) directions from said statement.  So there.

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/
#1 lore raw
Quoted 2 lines

Second, for agpgart I have to use try_agp_unsupported=1 which gets me
agpgart: Trying generic Ali routines for device id: 1647

Use the 2.4.1-ac patches, those should give you AGP

-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
Please read the FAQ at http://www.tux.org/lkml/