(2.4.1-ac15) pcmcia irq conflict
Upgrading from 2.2.18 and 2.4.0 to 2.4.1-ac15 broke pcmcia.
I have a Dell Inspiron 8000. Trying to use pcmcia with kernel (yenta_socket) or pcmcia-cs only causes pcmcia card to take irq 11, which my eth device is on also. This didn't happen with 2.2 or 2.4.0 kernels.
What param would I pass (how can I specify) to get yenta_socket to take say IRQ 9 or 10 on startup?
Thanks
Signature · 1 line
Jason Straight
Quoted 4 lines
I have a Dell Inspiron 8000. Trying to use pcmcia with kernel (
yenta_socket) or pcmcia-cs only causes pcmcia card to take irq 11, which my eth device is on also. This didn't happen with 2.2 or 2.4.0 kernels.
Sharing a PCI irq is legal, so that isnt the cause. It could be that the irq routing isnt getting handled correctly however.
Any suggestions of things I could try to help pinpoint the problem and let you know the results? Everything was fine before 2.4.1.
I've been using the pcmcia-cs without kernel pcmcia support up until it didn't work with 2.4.1, then I tried using the kernel pcmcia and no deal there either.
As soon as I try to start pcmcia my machine freezes. When using yenta_socket I can see that the TI pcmcia and eth0 (intel eepro100) are both on irq 11.
when using the pcmcia-cs way of it I tried "exclude irq 11" in config.opts and /etc/sysconfig/pcmcia set "PCIC_OPTS="irq_list=9,10,15 pci_irq_list=9,10,15" as was suggested in this post :
http://groups.google.com/groups?q=inspiron+8000+pcmcia+2.4.1&hl=en&lr=&safe=off&rnum=1&seld=929215370&ic=1
It didn't work for me - at least not with 2.4.1-ac13 to ac15
I didn't disable my minipci ethernet because I need it and if the IRQ's for pcmcia didn't use 11 now I wouldn't think I would need to.
Quoted 15 lines · Alan Cox
Quoted 4 lines
I have a Dell Inspiron 8000. Trying to use pcmcia with kernel (
yenta_socket) or pcmcia-cs only causes pcmcia card to take irq 11, which my eth device is on also. This didn't happen with 2.2 or 2.4.0 kernels.Sharing a PCI irq is legal, so that isnt the cause. It could be that the irq routing isnt getting handled correctly however.
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/
Signature · 1 line
Jason Straight