Skip to contentSkip to conversation

Hotswap ATA status ?

DISCUSSION David Balazic 2 participants 2 messages May 7, 2001

lore
Share & tools
lore
#0 lore raw

Andre , you promised ATA/IDE hot-swap on "normal" hardware several weeks ( months ? ) ago. What happened ?

Signature · 4 lines
David Balazic
--------------
"Be excellent to each other." - Bill & Ted
- - - - - - - - - - - - - - - - - - - - - -
#1 lore raw
Quoted 10 lines · David Balazic

Andre , you promised ATA/IDE hot-swap on "normal" hardware several weeks ( months ? ) ago. What happened ?

Signature · 4 lines
David Balazic
--------------
"Be excellent to each other." - Bill & Ted
- - - - - - - - - - - - - - - - - - - - - -

Well lets see.....

I lost my ISP (NorthPoint + PacBell) 4/18/2001
There was a T13 meeting the following week. 4/23/2001
Found a flaw in the tests of writecaching.
Reverified the contents of the CODE base to match SPEC 4/29/2001

Reverified that certain hosts are not good.
(oh two kids that were ill and then the wife)
Reconfigure the "CAVE" where I do all of my work.
Write 90% of 48-bit LBA, use/test the hostswap for large/huge drives. Look at the user API and chuckled then cried and roared aloud...... Figure out License for the "ide-service.o" module.
It will not be GPL but a very strict LAD (BSD-ish) License. Reasons will follow, but I will not be liable for stupid usage.

So if you are reallying dying to test code that has not been full shaken down and requires a huge page for the glue, I will post one.

The service utility is not ready yet so it is no good without one.

Regards,

Andre Hedrick
Linux ATA Development

PS I left a dump here and there.........but that was going to be WTMI