Uncompress Ok, but cannot run linux kernel...
Quoted 5 lines
Tom:
Quoted 9 lines
I stumbled into the same problem a while ago.
While I did not use a hardware debugger I used the sample demonstrating serial output to find that the Montavista kernel stops at the rfi instruction which is used to simultanoeusly turn on instruction and data address translation and to set the instruction pointer to the (remapped)
start_herelabel. Unfortunately I lost my PPC hardware (405GP Walnut board) before I could find any solution.
I meet same problem now.When I add CONFIG_MODULES into config file
HHL 2.2.14 works well(my borad is mpc850),but after add it ,I meet same situation :after uncompressing kernel ,it do noting.It shoud display LINUX_BANNER.
If you find the solution,tell me.Thanks.
Dross
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/