Intel 82815 VGA
Hi everyone.
Problem with i815EM chipset (in ASUS M1000 laptop series) -
the display blinks *VERY* frequently - seems to blink for every disk access or so.
I've tried the Intel XFCom XFree86 driver AND recompiling
the agpgart kernel module to no avail. Intel's kernel module fails compilation on any 2.4.x kernel, missing MAP_NR definition.
Anyone gone through the same situation? Patches to agpgart,
available anywhere?
lspci -v output:
00:00.0 Host bridge: Intel Corporation 82815 815 Chipset Host Bridge and Memory Controller Hub (rev 11)
Subsystem: Asustek Computer, Inc.: Unknown device
1402
Flags: bus master, fast devsel, latency 0
Capabilities: [88] #09 [f205]
00:02.0 VGA compatible controller: Intel Corporation 82815 CGC [Chipset Graphics Controller] (rev 11) (prog-if 00 [VGA])
Subsystem: Asustek Computer, Inc.: Unknown device
1402
Flags: bus master, 66Mhz, medium devsel, latency 0,
IRQ 11
Memory at f8000000 (32-bit, prefetchable) [size=64M]
Memory at f7800000 (32-bit, non-prefetchable)[size=512K]
Capabilities: [dc] Power Management version 2
00:1e.0 PCI bridge: Intel Corporation: Unknown device 2448 (rev 03) (prog-if 00 [Normal decode])
Flags: bus master, fast devsel, latency 0
Bus: primary=00, secondary=01, subordinate=01,
sec-latency=32
I/O behind bridge: 0000d000-0000dfff
Memory behind bridge: f7000000-f77fffff00:1f.0 ISA bridge: Intel Corporation: Unknown device 244c (rev 03)
Flags: bus master, medium devsel, latency 0
00:1f.1 IDE interface: Intel Corporation: Unknown device 244a (rev 03) (prog-if 80 [Master])
Subsystem: Asustek Computer, Inc.: Unknown device
1402
Flags: bus master, medium devsel, latency 0 I/O ports at b800 [size=16]
00:1f.2 USB Controller: Intel Corporation 82820 820 (Camino
2) Chipset USB (Hub A) (rev 03) (prog-if 00 [UHCI])
Subsystem: Asustek Computer, Inc.: Unknown device
1402
Flags: bus master, medium devsel, latency 0, IRQ 9 I/O ports at b400 [size=32]
00:1f.4 USB Controller: Intel Corporation 82820 820 (Camino
2) Chipset USB (Hub B) (rev 03) (prog-if 00 [UHCI])
Subsystem: Asustek Computer, Inc.: Unknown device
1402
Flags: bus master, medium devsel, latency 0, IRQ 9 I/O ports at b000 [size=32]
00:1f.5 Multimedia audio controller: Intel Corporation:
Unknown device 2445 (rev 03)
Subsystem: Asustek Computer, Inc.: Unknown device
1463
Flags: bus master, medium devsel, latency 0, IRQ 9
I/O ports at e000 [size=256]
I/O ports at e100 [size=64]00:1f.6 Modem: Intel Corporation: Unknown device 2446 (rev
03) (prog-if 00 [Generic])
Subsystem: Asustek Computer, Inc.: Unknown device
1466
Flags: bus master, medium devsel, latency 0, IRQ 9
I/O ports at e200 [size=256]
I/O ports at e300 [size=128]01:07.0 CardBus bridge: Texas Instruments PCI4410 PC card Cardbus Controller (rev 02)
Subsystem: Asustek Computer, Inc.: Unknown device
1464
Flags: bus master, medium devsel, latency 168, IRQ
11
Memory at f7001000 (32-bit, non-prefetchable)
[size=4K]
Bus: primary=01, secondary=02, subordinate=02,
sec-latency=176
Memory window 0: f7400000-f77ff000 (prefetchable)
I/O window 0: 0000d000-0000d0ff
I/O window 1: 0000d400-0000d4ff
16-bit legacy interface ports at 000101:07.1 FireWire (IEEE 1394): Texas Instruments: Unknown device 8017 (rev 02) (prog-if 10 [OHCI])
Subsystem: Asustek Computer, Inc.: Unknown device
1467
Flags: medium devsel, IRQ 9
Memory at f7002000 (32-bit, non-prefetchable)
[disabled] [size=2K]
Memory at f7004000 (32-bit, non-prefetchable)
[disabled] [size=16K]
Capabilities: [44] Power Management version 1
01:08.0 Ethernet controller: Intel Corporation 82820 820 (Camino 2) Chipset Ethernet (rev 03)
Subsystem: Intel Corporation: Unknown device 3013
Flags: bus master, medium devsel, latency 64, IRQ 9 Memory at f7000000 (32-bit, non-prefetchable)
[size=4K]
I/O ports at d800 [size=64]
Capabilities: [dc] Power Management version 2
Thanks
Ricardo Oliveira.
----
Ricardo Manuel Oliveira
Eurotux Informática, SA
Tel: +351 253257395 // +351 919475934
Fax: +351 253257396
Quoted 3 lines
Problem with i815EM chipset (in ASUS M1000 laptop series) -
the display blinks *VERY* frequently - seems to blink for every disk access or so.
It shouldnt be affected by PCI traffic but I guess its possible someone has been sawing bits off. Try turning off ide DMA
(hdparm -d0 /dev/hda)
Alan
Quoted 7 lines · Alan Cox
Quoted 4 lines
Problem with i815EM chipset (in ASUS M1000 laptop series) -
the display blinks *VERY* frequently - seems to blink for every disk access or so.It shouldnt be affected by PCI traffic but I guess its possible someone has been sawing bits off. Try turning off ide DMA
I keep getting emails from people which have seen my post.
To all of them (and everyone else):
There's an undocumented bit in an undocumented register in
the built-in graphics device of Intel's i810 (i815?) chipset (GMCH). Setting that bit to a 1 solved out this problem (which someone affectuously called 'the damn blinking problem').
Get the code at http://www.cl.cam.ac.uk/~pb/wmi810.tar.gz ,
compile, install, read the README/INSTALL. It's as simple as that.
To everyone who has tried to help in this mailing list, my
apollogies. This should be fixed in the XFree driver (I hope it'll be fixed in the next release). Also, my thanks to every single one who tried to help.
----
Ricardo Manuel Oliveira
Eurotux Informática, SA
Tel: +351 253257395 // +351 919475934
Fax: +351 253257396