Skip to contentSkip to conversation

2.4.11 : long delay in USB during boot

DISCUSSION Igor Bukanov 1 participant 1 message Oct 10, 2001

lore
Share & tools
lore
#0 lore raw

I updated my Dell Inspiron 7500 notebook (Celeron 466/512 MB) to 2.4.11 and during boot got the following:

uhci.c: USB Universal Host Controller Interface driver v1.1
PCI: Found IRQ 5 for device 00:07.2
PCI: Sharing IRQ 5 with 00:08.0
uhci.c: USB UHCI at I/O 0x1060, IRQ 5
usb.c: new USB bus registered, assigned bus number 1
usb: raced timeout, pipe 0x80000000 status 0 time left 0
usb: raced timeout, pipe 0x80000180 status 0 time left 0
usb: raced timeout, pipe 0x80000180 status 0 time left 0
usb: raced timeout, pipe 0x80000180 status 0 time left 0
usb: raced timeout, pipe 0x80000180 status 0 time left 0
usb: raced timeout, pipe 0x80000100 status 0 time left 0 hub.c: USB hub found
usb: raced timeout, pipe 0x80000180 status 0 time left 0 hub.c: 2 ports detected
usb: raced timeout, pipe 0x80000180 status 0 time left 0
usb: raced timeout, pipe 0x80000100 status 0 time left 0
usb: raced timeout, pipe 0x80000100 status 0 time left 0

It took about 8s to proceed farther. Are these messages/very long delay normal? I did not get them prior 2.4.11.

Here are uncommented lines with USB substring from my .config"

CONFIG_INPUT_IFORCE_USB=m
CONFIG_USB=y
CONFIG_USB_DEVICEFS=y
CONFIG_USB_BANDWIDTH=y
CONFIG_USB_UHCI_ALT=y
CONFIG_USB_BLUETOOTH=m
CONFIG_USB_STORAGE=m
CONFIG_USB_HID=m
CONFIG_USB_KBD=m
CONFIG_USB_MOUSE=m
CONFIG_USB_SERIAL=m
CONFIG_USB_SERIAL_GENERIC=y
CONFIG_USB_SERIAL_BELKIN=m
CONFIG_USB_SERIAL_WHITEHEAT=m
CONFIG_USB_SERIAL_DIGI_ACCELEPORT=m
CONFIG_USB_SERIAL_EMPEG=m
CONFIG_USB_SERIAL_FTDI_SIO=m
CONFIG_USB_SERIAL_VISOR=m
CONFIG_USB_SERIAL_KEYSPAN_PDA=m
CONFIG_USB_SERIAL_KEYSPAN=m
CONFIG_USB_SERIAL_MCT_U232=m
CONFIG_USB_SERIAL_OMNINET=m

Regards, Igor